RECTIFICATION
Journal Title: Metrology and Measurement Systems - Year 2008, Vol 15, Issue 2
Abstract
Unfortunately, in the issue number 1/2006 Metrology and Measurement Systems in the article: Zygmunt L. Warsza “Two-parameter measurements and signal conditioning in double – current supply four – terminal resistance circuits” has been error in contents of the Fig. 2. The correct contents of this figure is given below.
Authors and Affiliations
ZYGMUNT WARSZA
Keywords
Related Articles
- EP ID EP123845
- DOI -
- Views 69
- Downloads 0
DSP BASED POWER QUALITY ANALYZER FOR DETECTION AND CLASSIFICATION OF DISTURBANCES IN A SINGLE-PHASE POWER SYSTEM<br />
This paper describes the prototype of a power quality analyzer designed for real-time detection and classification of disturbances that occur in a single-phase power system. The standalone DSP-based analyzer implements p...
NEW CONCEPT OF A MEASUREMENT PROBE FOR HIGH IMPEDANCE SPECTROSCOPY
The paper presents a new measurement probe working as the input circuit for a high impedance spectroscopy analyzer. The probe allows to measure impedance in the range of 100 Ω < |Zx | < 100 GΩ. The probe extracts t...
THE RECONSTRUCTION OF WAVEFORMS OF IMPULSIVE STRAIN OCCURING IN AN ELASTIC BAR BY MEANS OF DECONVOLUTION IN THE FREQUENCY DOMAIN<br />
The paper presents a method of reconstruction of impulsive strain waveforms based on deconvolution in the frequency domain and the spectral transmittance of the bar, which was determined experimentally and given in an an...
HE INFLUENCE OF THE BALL MATERIAL ON THE BRINELL HARDNESS
A Brinell hardness tester with carbide and steel balls was calibrated and thereafter the hardness of ten samples of steel STN 41 1600 was measured by four appraisers. The uncertainty of calibration and of the hardness me...
PROF. DR HAB. INŻ. STANISŁAW ADAMCZAK HONORIS CAUSA DOCTORATE, UNIVERSITY OF ZILINA (SLOVAKIA)
On 16 November 2007, Prof. dr hab. inż. Stanisław Adamczak, Dean of the Faculty of Mechatronics and Machine Building at the Kielce University of Technology, member of the Committee on Metrology and Research Equipment and...