Recycling of Hematite Fine Waste by Pelletisation
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2017, Vol 40, Issue 3
Abstract
A large volume of by-products and residues is generated during iron and steel production. Much of these represents valuable materials and can be recovered and recycled inside the flow of integrated steel plants. The fine-grained residues, which are rich in iron, are usually recycled through sinter plants. This study aims at investigating the potential of palletization of two types of hematite fine waste resulted from process of chemical pickling of steel strip. The pelletizing tests were performed in an experimental disc pelletizer. The hematite was mixed with different fluxing and binding agents. The green pellets were then dried, sintered and cooled. The effect of materials mixtures on the physical and chemical characteristics of pellets was determined and analyzed in relation with nature of pelletized components.
Authors and Affiliations
Anișoara CIOCAN, Beatrice TUDOR
Keywords
Related Articles
- EP ID EP573878
- DOI -
- Views 56
- Downloads 0
Making Cast Piece Using Exothermic Head
In this paper presents a study about cost of part obtained with exothermal heads by replacement of classic heads. This method contributes to conduct solidification of cost pieces, because exothermal heads are forecast wi...
Surface Tension of Liquid Copper in Dilute Oxygen Concentrations
The studies of this paper regarding the influence of low oxygen contents on the liquid copper surface tension had as base „sessile drop” method and the determination of the oxygen content using calculation ratio where pa...
Electrical Properties of Ultra-Sonicated Epoxy Resin
As ultra-sonication is a mostly used method to disperse the particles into the polymer matrix, the aim of this study is to point out the effect of epoxy’s exposure to ultra-sounds over the electrical properties, especial...
Influence of Atmospheric Conditions on the Mechanical Properties of Pet Rubber Composites
The aim of paper is to study the influence of environmental open air conditions on the PET-rubber composites. Two set of samples (Type I, Type II) were obtained with the same composition, but the composites of Type I are...
The Influence of the Heat Treatment upon the Resistance to Corrosion of the Composite Obtained Using the Electrodepositing of TiO2 in a Nickel Matrix
The resistance to corrosion of a composite material obtained using the electrodepositing of TiO2 in a nickel matrix subjected to heat treatment was studied using the galvanostatic method; the samples were obtained by the...