Research of the Parameters of Cut For the Machining of the New Concretes
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2017, Vol 7, Issue 6
Abstract
The composite materials are largely used (aeronautical), because of their advantageous mechanical properties (weight ratio/resistance). Because of the complexity of the phenomena presenting the zone of cut, current knowledge on their machining is limited and prevents their optimal use. From their constitution, these materials pose many problems during their machining. The objective of this study is to seek the parameters of cut during the composite machining of materials Concrete High efficiency (HPC) and Concrete Fiber High efficiency (HPCF). The latter are proposed for the manufacturing of the molds to carryout composite material parts, but the materials used for the manufacturing of the molds of the composite material parts like polyester, silicone and resin epoxy etc., do not resist to high temperatures, and also to analyze the behavior of the composite concrete during machining. Allowing to avoid the appearance of the defects (heating and wear of the cutting tool). An experimental design of machining of some tests was defined for the research of the parameters of cut (cutting speed Vc, depth of cut ap and advances by turn f). The variation of the parameters of cut for each test showed that machining after treatment, caused problems at particular level as in cutting tools and the appearance of the quoted defects.
Authors and Affiliations
A. Chaoufi, M. Zaoui, S. Tafraoui
Keywords
Related Articles
- EP ID EP254587
- DOI -
- Views 96
- Downloads 0
Eign-Limits Uncertainty Methodology for Temperature Calibration by Fixed Points and Comparison
Calibration measurement uncertainty of Platinum Resistance Thermometer (PRT) was estimated in International Temperature Scale 1990 (ITS-90) at defined fixed points [1]but it was not gives a criteria to find the uncertain...
STATIC STRUCTURAL ANALYSIS OF AN ADVANCED POWER TILLER CHASSIS AND CHISEL PLOUGH
The rapid increase in industrialization and technology has shifted the agriculture sector into themodern era, which also resulted in labor scarcity and rise in investment. In developing countries like India, there are 89...
Effect of Gap Condition Between Two Composite Plates in Ballistic Resistance Tests
There is a great need to improve the efficiency of bulletproof vests, especially those, which made from composite materials for many reasons including protecting lives of individuals and finding the best materials and ar...
Thermal and Mechanical Properties of Epoxy Hybrid Composites
Two different mineral particulates Graphite/Granite filled cross breed composites is readied by scattering into the Epoxy as the centre material utilising tenet of half and half blends (Rohm). Mechanical properties like...
Optimisation of Process Parameters in Water Jet Peening on AA6063 Aluminium Alloy by Response Surface Methodology
Water Jet Peening (WJP) is a modern non-traditional surface treatment process which is used to improve the surface integrity of a material. In this study Aluminium Alloy (AA 6063) is subjected to Water jet peening surfac...