RESEARCH OF WEAR OF RUBBER PLATES TO BE APPLIED AS A LINING MATERIAL IN MINES
Journal Title: Tribologia - Year 2012, Vol 244, Issue 4
Abstract
The article presents the research results of the wear of rubber samples being applied as protective plates in mines. The samples were abraded by abrasive loose particles. The particles were both sliding and impacting the surface layer of rubber sample while in drum-tube rotation. The weight method was used to measure wear. The rubber surface was also analysed with the aid of a microscope. It was concluded that the hardness of rubber has influence for the its wear. EPDM and Silicone rubbers with 60Shore degree hardness, the maximal had Viton 75Shore has the lowest loosening of mass. Materials with vulcanised fibres had the higher wear than materials without fibres.
Authors and Affiliations
Janusz Rogula
Keywords
Related Articles
- EP ID EP270427
- DOI -
- Views 39
- Downloads 0
Charakterystyki tribologiczne pary ślizgowej: warstwa Al2O3/WS2–tworzywo sztuczne PEEK/BG
Celem artykułu jest przedstawienie wyników badań tribologicznych skojarzenia warstwa tlenkowa Al2O3 modyfikowana WS2 z tworzywem sztucznym PEEK/BG. Analizowane właściwości tribologiczne obejmują wyniki badań intensywnośc...
Właściwości tribologiczne kompozytów kauczuku butadienowo--akrylonitrylowego zawierających nanorurki węglowe
THE ANALYSIS OF HYDRODYNAMIC PRESSURE DISTRIBUTION AND LOAD CARRYING CAPACITY IN THE GAP OF SLIDE JOURNAL BEARINGS WITH MICRO-GROOVES
The purpose of this paper is to analyse the distribution of hydrodynamic pressure, load carrying capacities, and friction force in the gap of the slide bearing on account of the type, number, and size of micro-grooves on...
IN-SERVICE ABRASION RESISTANCE EXAMINATIONS OF METAL SHEET LININGS USED IN THE BUCKET WHEEL FOR THE SRs 1200 WHEEL EXCAVATOR
This paper compares the abrasion resistance (values) of metal sheets forming a rotating chute of the bucket wheel in the wheel excavator operating in a brown coal mine. Six different types of metal sheets, including thre...
Charakterystyka zużycia stempla podczas wyciskania stalowych elementów
W pracy opisano mechanizm zużycia stempla wykonanego ze stali 32CrMoV12-28 używanego do wyciskania bufora zderzaka kolejowego. Stempel ten uległ pęknięciu, które wyeliminowało go z dalszej eksploatacji. Wykonano charakt...