Research on Preparation and Application of Low Volatile PA66 Composites
Journal Title: Automobile Technology & Material - Year 2024, Vol 39, Issue 2
Abstract
PA66 material has good heat resistance and is widely used in heat-resistant parts of lamps. However, because it is prone to thermo- oxidative decomposition, the small molecular substances decomposed are easy to form fog deposits, which affect the appearance, performance and service life of lamps. Therefore, the study of low-volatile PA66 composites is an urgent issue to be solved. This paper investigated the effects of antioxidants, molecular sieves,PA10T, processing technology and other factors on the volatility of PA66 composites under thermo-oxidative aging, and analyzed the main components of volatiles. It concluded that the copper salt (0.5 wt%) + PA10T (30 wt%) + double vacuum scheme had better fogging, and proved to meet the requirements.
Authors and Affiliations
Liu Jialin
Keywords
Related Articles
- EP ID EP731939
- DOI 10.19710/J.cnki.1003-8817.20230109
- Views 56
- Downloads 1
Solution of Section Parameter of Drawbead in Z-Direction Based on AutoForm
In order to solve the problem that the cross-sectional parameters of AutoForm drawbead could not be directly used in 3D software design, this paper derived solution formula for the cross- sectional parameters of Z-direct...
Multi-Step in Situ Preparation Tib2 Particle-Reinforced Copper Matrix Composites for Spot Welding Electrodes and Their Applications
In order to improve the service life of spot welding electrodes, TiB2- reinforced copper matrix composites were prepared using a multi- step method. The physical phase and microscopic morphology of the TiB2-reinforced co...
Research on the Formability of Aluminum Sheet Rear Door Inner Plate Based on AutoForm Analysis
To address the issue of difficulty in designing and producing aluminum plate rear door inner plate caused by poor formability and ductility of aluminum plate material, complex shape of rear door inner plate, this paper...
Cause Analysis and Optimization of Flange Cracking for Cross Member of Steel H420LAD
For the problems of flange cracking for cross member of steel H420LAD, the stamping simulation of cross member was performed, the scheme was evaluated on type of flange, major and minor stain, paths of strain. The resul...
Research on Weak Magnetic Inspection of Axle Steel Carburizing Layer Depth
To deal with the limitation of the existing non- destructive testing technology for the depth of the carburized layer of axle steel, a weak magnetic detection method is proposed. Since the stress concentrates at the jun...