Researches Regarding the Elements Loss through Vaporization during the Elaboration Process in LD Converter
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2009, Vol 32, Issue 2
Abstract
The paper presents a series of researches regarding the vaporization of the component elements of the metallic bath and slag during refining in LD converter. Also, the main factors which influence the vaporization process during steel making in LD converter are studied: the converter atmosphere; the carbon content of the metallic bath; the speed of the oxygen jet; the temperature of the metallic bath; the blowing diagram. Based on these researches we sought to obtain a technology of steel making in LD converter so that the percentage of losses by vaporization is minimum.
Authors and Affiliations
Alexandru IVANESCU, Ana DONIGA, Elisabeta VASILESCU, Lilica IVANESCU
Keywords
Related Articles
- EP ID EP655760
- DOI -
- Views 63
- Downloads 0
The Environmental Impact Assessment of a Municipal Landfill - A Study on the Leachate
The increase in consumption draws the need to quickly assess the problem of the municipal solid wastes. On the short term, the easiest way to deal with this stringent problem seems to be landfilling. This method was alwa...
Research on Abrasive Wear Behavior of Laser Cladding Layers of High - Speed Steel Powder Type HS6-5-2 - M2
The paper presents the wear behaviour on a rotating disk which carried abrasive paper of laser cladding layers with high-speed steel powder type HS6-5-2 - M2 compared to steel samples of the same quality but heat treated...
Quality Surface Analysis for Polarized Grid Plasma Nitridings
For the study regarding the effect of the polarized grid a prototype plasma nitriding facility was used. A polarized grid was placed inside the working chamber, into the space between the anode and cathode, a negative po...
The Influence of the Temperature Regime on the Mechanical Properties of the Thick Steel Sheets from Carbon and Low-Alloy Steels, Laminated to Thicknesses Less than 40 mm
Steel remains the most used material in the machinery industry, the construction of oil and gas pipelines, etc. Hot rolling is no longer a simple means of obtaining the final geometry of products in the steel industry, b...
EDX Analysis of Laser Cladding Layers With Ni – Cr – B – Fe – Al Alloy
Multilayer cladding by injection of powder with 8.9% Cr, 4.5% Fe, 5.1% B, 2.4% Al, 0.6% Cu, Ni rest as chemical composition, in melted bath by a continuous wave CO2laser connected to x-y-z coordinate table was tested in...