Rubber Additions into Concrete and Gamma Radiation Effects on Mechanical Properties and Microwave Absorption Capacity
Journal Title: Journal of Nuclear Physics, Material Sciences, Radiation and Applications - Year 2017, Vol 5, Issue 1
Abstract
Rubber is the indispensable raw material for the manufacture of tires; it is obtained from plants, trees and currently can be produced synthetically. The tire rubber is mixed with compounds such as carbon black, sulfur, cement, paints, antioxidants, oils and fats, steel wire, almost etc., making impossible to recycle the tires itself. In this work, we investigate, the effects of the incorporation of ground rubber in concrete, mixture designed to establish the possibility of being used in the construction industry. The samples of concrete were addition with, 5 vol. %., 15 vol. % and 25 vol. % of rubber. Samples with different rubber addition were irradiated by a cobalt 60 gamma source to study the effect on their mechanical compression properties and microwave absorption capacity. Likewise, the microwave absorption capacity was studied for both irradiated and the non-irradiated. It was found that between 5 vol. % and 15 vol. % of rubber addition change the mechanical properties approximately 25 %, higher rubber additions result in a decrease in a 75 % of its mechanical properties. The fracture behavior is not the expected one due to as the curves of stress vs. strain show a double slope, which is associated with the concrete porosity and rubber content. The aging with the gamma rays generates loss of mechanical properties, especially at lower rubber addition, since at content greater than 15 Vol % the radiation effect is less. These rubber additions allow moderate deformations in compression, thus contributing to the care and preservation of the environment.
Authors and Affiliations
J. Colín, F. Castillo, B. Leal, O. Flores, I. Gamboa, H. Martínez
Keywords
Related Articles
- EP ID EP595511
- DOI 10.15415/jnp.2017.51019
- Views 232
- Downloads 0
Calcium Hardness Analysis of Water Samples Using EDXRF Technique
Calcium hardness of water samples has been determined using a method based upon the energy Dispersive X-ray fluorescence (eDXRF) technique for elemental analysis. the minimum detection limit for Ca has been found in the...
The Meijer’s G-functions Convenient for Describing β & γ-decays
The purpose of this paper is to show that the Meijer’s G-functions, as a very general complex functions which include all elementary, and most of the special functions, can describe some phenomena in nuclear physics. In...
Characterization of Zinc Nanoferrite Doped HPMC Polymers Using X-Ray Diffraction
HPMC Polymer composites were prepared by doping various concentrations of Zinc ferrite nanoparticles using solution casting method. These polymer composites were characterized using X-Ray Diffraction and conductivity mea...
Synthesis of MgB4O7:Dy3+ and Thermoluminescent Characteristics at Low Doses of Beta Radiation
The synthesis and thermoluminescent characteristics of dysprosium-doped MgB4O7 are analyzed. The phosphor at different concentrations (0, 0.1, 0.5, 1, 2 and 4 mol%) of the dopant was prepared by the solution-assisted met...
Electrochemical Characterization of Cathodized Copper Oxide Thin Films
Cathodic electrodeposited copper oxide thin films were prepared using 0.1 M aqueous (distilled water) copper sulphate solution onto the surface of stainless steel substrates. Deposited samples were characterized for stru...