Shunt Active Power Filter for Remove Harmonics Using Conventional PI and Fuzzy Logic Controllers
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2018, Vol 13, Issue 3
Abstract
The widespread use of power electronics devices such as inverter, rectifier, and so on. in power systems causes severe problems linked to power quality. The widespread use of nonlinear single-phase power electronic devices in the low voltage side has increased harmonic pollution in power systems to the large extent. One such problem is the generation of current and voltage harmonics causing the distortion of load waveform, heating of equipment, voltage fluctuation, voltage dip, etc. This paper provides a detailed study of shunt active power filter under two current control strategies, namely, p–q and d–q; their comparative analyses are performed to determine which method is better than the other. In both methods, a reference current is generated for the filter, which compensates either the reactive power or the harmonic current component in a power system. In this work, a current controller, known as the harmonic current controller, is described, which is used to provide remedial gating sequence of the IGBT inverter and thus helps remove the harmonics component. For proper pulse generation, conventional PI controller and fuzzy logic controller are used in this paper. A comparison of both the controllers is conducted, which highlights the superiority of the fuzzy logic control scheme.
Authors and Affiliations
Mr. M. Yugandhar Naidu, Ms. Yp. Swapna, Dr. D. Obulesu
Keywords
Related Articles
- EP ID EP388766
- DOI 10.9790/1676-1303024861.
- Views 145
- Downloads 0
The Comparision of Energy Production of Monocrystalline And Policrystalline Solar Panel By Using The wirelessly And Measurement of Energy
Today, electrical energy demand is increasing day by day. I need a situation like this, the signs of the development of the electric energy country came into being. Parallel does not increase. Electric energy production...
Optimizing Power Loss on Nigerian Weak Transmission Line Using Facts Devices and Genetic Algorithm
This research focuses on the optimization of power loss on Nigerian 330kV, 30-bus transmission line by installing high power electronics called FACTS device to improve the key parameters (line impedance, phase angle and...
Modeling And Simulation of Loads Into Existing Distribution Network System Using MATLAB/Simulink
This paper presents the detail model of load and other devices in distribution network systems (DNS). Simulation and modeling is done using MATLAB/Simulink software package. The proposed model is user friendly and can be...
Design and Implementation of Astable Multivibrator using 555 Timer
The 555 timer is widely used as IC timer circuit and it is the most commonly used general purpose linear integrated circuit. It can run in either one of the two modes: Monostable (one stable state) or Astable (no stable...
Adaptive Pi Control of Statcom for Voltage Regulation
Static compensator (STATCOM) can provide fast and efficient reactive power support to maintain power system voltage stability. In the literature, various STATCOM control methods have been discussed including many applica...