Sistem Criate Hight Vojltag Frequency-Impuls Electric Fields for the Obtaining Stress-Strain Surface
Journal Title: Фізика і хімія твердого тіла - Year 2014, Vol 15, Issue 3
Abstract
In this article development and criate new model phizical-technical obtaining material technological equipment the method higth-friquency plazmy plating-flame carboids and nitralloy cohesion hight-temepature metal IV - VI grope. Experimental description was lengthen for the creation technology layer surface instrumental steel in width temperature 300 – 600 K . Design technology and method experiments on equipment in term mechanical,rentgenografics and faise analisis for the adoption,recognition and resume.
Authors and Affiliations
A. S. Zavojko
Keywords
Related Articles
- EP ID EP317741
- DOI -
- Views 49
- Downloads 0
The Influence of Technological and Tribological Factors on the Aftereffect and Wear Resistance of Polymer Composites
The anti-wear properties of polymer composites based on polytetrafluoroethylene with not metallized and metallized carbon fibers in conditions of friction and wear in over limit and limit of specific loads have been rese...
Topology of Surface of ZnO thin Oxide Film Formed on GaSe Layered Crystal Surface
Heterostructure n-ZnO ( p-GaSe was prepared by the magnetron sputtering method. Topology of surface of ZnO thin oxide film formed on freshly cleaved surface of GaSe layered crystal was investigated; sensitivity spectral...
Effect of laser irradiation on Electrochemical Properties of composite MoS2/C
The paper presents the results of studies of electrochemical properties of composite MoS2/C. It is shown that the contribution to the conductivity of composites makes a charge accumulation capacitive nature inherent in h...
Effect of Al, Fe Addition on Thermodynamic Stability and Hydrogen Desorption KInetics from MgH2 Phase OF Mechanical Alloy
With the aim of lowering the temperature, improve the kinetics of the decomposition of stoichiometric hydride MgH2 was investigated the possibility of its complex doping Al, Fe using mechanochemical synthesis (RMS). The...
Peculiarities in WC and W2C Eutectic Phases Dissolution in Interfacial Zones of Composites
Annotation: The structural and phase composition of dissolution-and-diffusion interfacial zones at the particle-matrix interfaces of the composites reinforced with W–C particles infiltrated by a molten iron-base binder h...