Stability analysis of MRASCC speed estimator in motoring and regenerating mode
Journal Title: Power Electronics and Drives - Year 2016, Vol 2, Issue 2
Abstract
Background: This paper deals with the stability analysis of MRAS current speed estimator in a motoring and regenerating mode. The problem of unstable operating points of the estimator, mainly in a regenerating mode are widely discussed. Material and methods: The control theory methods have been used for the analysis of the speed estimator performance in whole operating range, including motoring and regenerating modes. Based on the analysis of the linearized estimation error equation the unstabe operating point are determined. Simulation tests in Matalab/Simulink have been used for confirmation of theoretical analyses. Results: The expanded version of the estimator MRAS_CC is proposed to provide its stability in the whole operating range. The new correction coefficients for two analyzed stabilization methods are proposed. Finally, simulation results confirming the theoretical analysis are presented. Conclusions: Analysis of the determinant of the state matrix of the linearized estimation error equation allows to determine the appropriate elements (coefficients of the gains matrix or shift angle between the stator current error and the rotor flux vectors) stabilizing the MRAS_CC estimator operation in the regenerating mode and to reduce the range of unstable operation points to the straight line D1 (ws0=0).
Authors and Affiliations
Mateusz Korzonek, Teresa Orłowska-Kowalska
Keywords
Related Articles
- EP ID EP175058
- DOI -
- Views 51
- Downloads 0
INDUSTRIAL DRIVE SYSTEMS. CURRENT STATE AND DEVELOPMENT TRENDS
The article presents the current state and development trends of electrical drives, with particular em-phasis on modern control structures and safety systems of various types of electrical machines. Special attention was...
Physical phenomena existing in the turbogenerator during faulty synchronization with inverse phase sequence
Background: Electrical machines Material and methods: Finite element method Results: The great emphasis is placed on the physical phenomena existing the rotor because the measurement of rotor damper bar currents is diffi...
Model Predictive Control of Four-Leg Three-Level Flying Capacitor Converter: Influence of Model Parameter Mismatch
This paper presents a control method for a four-leg three-level flying capacitor converter (FCC) operating as a shunt active power filter (SAPF), based on model predictive control with finite number of control states (FS...
MODIFIED SCHEME OF PREDICTIVE TORQUE CONTROL FOR THREE-PHASE FOUR-SWITCH INVERTER-FED MOTOR DRIVE WITH ADAPTIVE DC-LINK VOLTAGE IMBALANCE SUPPRESSION
These instructions The classical voltage space vector modulation techniques cannot be efficiently applied in four-switch three-phase voltage inverter-fed electrical drives due to a voltage offset in DC-link capacitors. T...
Effects of the grid disturbances on Current Source Rectifier controlled by FCS-MPC algorithm
Nowadays, the increasing number of nonlinear loads influence the grid causing grid voltage disturbances. Those disturbances may be very dangerous for the equipment and can create faults in converters behavior. However, t...