Study of stabilization processes of amplitude quality of ore flow of iron-ore open-pit mine
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2018, Vol 81, Issue 1
Abstract
The article defines the conditions and significance of managing the quality of ore in an open-pit mine, presents the results of the analysis of the state and factors influencing the fluctuations of the quality of iron ore raw materials in the quarries of the Krivbass mining and processing enterprises, taking into account the rhythm of the work of the quarry equipment and transport, as well as formulated the problem of creating a generalized quarry system for managing the quality of ore flows and directions for its solution by integrating all elements of the system and optimizing the modes of paired operational reloading their nodes in the chain of stabilization of quality in the formation of ore flow. In iron-ore quarries with COT technology, unloading of the rock mass in the ore outlet is carried out by dump trucks in a turn-by-turn mode, when discrete volumes of the ore mass are mixed and form the flow. In this case, the ore from the faces with a minimum and maximum content of the useful component has the greatest impact on the amplitude fluctuations of the quality of the ore stream. One of the ways of smoothing the fluctuations of the quality of iron ore raw materials is the use of the method of dual unloading, which aims to stabilize the quality of the quarry ore quarts due to the pairing of vehicles transporting ore from the benches with the maximum and minimum content of the useful component.
Authors and Affiliations
V. A. Azarіan, S. O. Zhukov
Keywords
Related Articles
- EP ID EP311548
- DOI -
- Views 113
- Downloads 0
The optimization of predicting the liquefy of pulp in a ball mill at variable flow of water in sand of the classifier
To diminish the cost of iron-ore concentrate is possible by stabilization in the ball mill ratio ore / water, and this work is devoted to find it. In this work we used an algorithmic approach of the determination of the...
Development of a module for measuring concentrations of harmful and explosive gases in a mini unmanned aerial vehicle
The development is carried out on the basis of the sensor of harmful and explosive gases. In the work, the authors proposed a scheme that provides a stable output signal containing measurement information about the gas c...
Methods of control the machining process
Presents control methods, differentiated by the time of receipt of information used: a priori, a posteriori and current. When used a priori information to determine the mode of cutting is carried out by simulation the pr...
Diamond surface finishing of ceramic balls from boron carbide
The article experimentally investigates the influence of factor of machining conditions on diamond surface finishing of ceramic balls from boron carbide. The indicators of machining are rate of work removal parameter, ra...
Design and investigation of electronic unit of a pyrometer for measuring flux fadiation of solid particles in a two-phase flow
The work offers the improvement of oxygen monitoring instrument of a gas torch with the use of a simple tool base which does not demand a high level of qualification of operator. An electronic block of pyrometer was deve...