Studying the Influence of River Works on River Flow Regime with 1-D Hydraulic Modelling
Journal Title: HIDRAULICA - Year 2018, Vol 0, Issue 3
Abstract
The one-dimensional (1-D) hydraulic models are the most adequate for river modelling flow. This case study involves the rehabilitation of the CFR bridge, km 38 + 389, line 116 DII Simeria - Petrosani at Ruşor town, Hunedoara county. Therefore, the Ruşor River is being thought through, with a series of complex river works of the river bed and channel, in order to regulate the flows near CFR Bridge. To prevent future possible damages, a 1D hydrodynamic model of the Ruşor river sector was developed, highlighting the effect of the river regularization works. The hydraulic model was built with HEC-RAS 4.0 software, for two flow simulation scenarios: natural river flow and regulated river flow. Following the simulation of the hydrodynamic modelling, a significant reduction in the flow rates within the calculation reach was observed.
Authors and Affiliations
Marie-Alice GHITESCU, Albert Titus CONSTATIN
Keywords
Related Articles
- EP ID EP483819
- DOI -
- Views 155
- Downloads 0
Simulation of an Electro-Hydraulic System for a P.E.T. Waste Baling Press
Energy efficiency is nowadays a key factor in designing industrial machinery, where digital technologies, modeling and simulation software environments are beginning to have a deeper impact. Smart technologies have enter...
A Method to Address the Fixing of Sealing Deficiencies at the “Ostrovul Mic” Left Bank, “Râul Mare - Downstream” Water Development
The present paper proposes a method for approaching the remediation of sealing deficiencies from the left bank of Ostrovul Mic water reservoir at km1+300 (Raul Mare – Downstream water development) by executing a drain at...
Fluid Flow Particularities within Hydraulic Working Circuit
As is known from the principles of fluid mechanics, the flow phenomenon of the working fluid within a hydraulic circuit is always accompanied by energy losses that are inevitably determined by the frictional forces with...
Theoretical and Experimental Research on the Technological Process of Spraying and Dynamics of the Motorized Agricultural Platform
This article presents the results of a research developed by INOE2000 - IHP, as well as a functional model of a motorized agricultural platform used for spraying in horticulture. This is part of a complex crop monitoring...
Influence of the Rotating Piston Shape on the Flow Rate of a New Type of Rotating Working Machine
The paper presents a new constructive solution for a rotating pump that contains two profiled rotors; each rotor has two pistons that may be triangular or curvilinear (oval). The area difference of the two pistons in a c...