TESTING OF THE STATE OF STRESSES AFTER FINISH BURNISHING ITEMS
Journal Title: Journal of Machine Construction and Maintenance - Year 2018, Vol 108, Issue 1
Abstract
The article presents the results of studies on the formation of residual stresses due to finish burnishing. Improper state of stresses may arise when, seeking higher dimension and shape accuracy, smaller roughness, or improved plateau area, the production engineer is willing to apply high and very high burnishing forces Fb. Plastic deformations in roughness created by burnishing can be easily measured with modern profilometers. However, each finish burnishing cut is accompanied by a state of stresses, some of which are residual stresses that remain in the item after machining. Excessively high stresses during the use of products are often causes of the cracking and flaking of surface fragments [1, 2]. One of most accurate methods for the evaluation of residual stresses after burnishing is their modelling taking into account the mechanical properties of material and technological parameter values used in the course of machining. The authors discuss the method of developing an experimental model, its testing, and verification of the results.
Authors and Affiliations
Daniel Grochała, Stefan BERCZYŃSKI, Zenon GRZĄDZIEL
Keywords
Related Articles
- EP ID EP615622
- DOI -
- Views 147
- Downloads 0
ASSESSMENT OF ALTERNATIVE SURFACE MODIFICATION TECHNOLOGIES FOR IMPROVED ADHESION OF COATINGS AND ADHESIVES TO AUTOMOTIVE POLYOLEFINS
Thermoplastic olefins (TPO’s) are important materials for the manufacture of exterior and interior automotive components due to their low cost, reduced specific density in comparison with other types of plas...
VIBROACOUSTIC DIAGNOSTICS OF DEFECTS OF COMBUSTION ENGINES VALVES
The problem of the diagnostics of mechanical defects of combustion engines, especially of exhaust valves damages, occurs in several papers. Authors of these papers apply various inference techniques and limit investigati...
A METHOD OF SCREW THREAD MEASUREMENT USING A 3D VISION SYSTEM
This paper presents a method allowing for the quality inspection of a screw thread directly on a production line. The parameter evaluation was performed on a surface partial image obtained using 3D laser tri...
AN ANALYSIS OF MECHANICAL PROPERTIES OF POROUS MATERIAL WITH COILED WIRE
This article examines the skeleton structure of a product from porous permeable material based on a wire coil. The product consists of a round, porous, thin-walled tube. Two variants of tube load are consid...
TUNGSTEN DOPED TiB2 COATINGS OBTAINED BY MAGNETRON SPUTTERING
The aim of the work was to investigate the possibilities of shaping the properties of TiB2 coatings by doping with tungsten, which create hard boron phases (e.g., WB2, WB4, and W2B5). The coatings were produced by a DC m...