The desctiption of turn-off process and evaluation of switching power losses in the ultra fast power MOSFET
Journal Title: Power Electronics and Drives - Year 2016, Vol 1, Issue 1
Abstract
Background: The article provides a detailed analytical description of the turn-off process in a high-voltage power MOSFET, with nonlinear junction capacity. With the use of a gate circuit with a low resistance and considering the internal parasitic parameters of the switch, the phenomena occurring during switching process inside the semiconductor structure are crucial to correct determine the value of the energy dissipated in the transistor. A full explanation of these phenomena is quite difficult because of the limited experimental measurements inside the transistor. Material and methods: To explain, simulation studies in Pspice for modelling switching transients was developed. To estimate switching losses an original thermovision method based on the measurement of heat dissipated in the power semiconductor switches has been used. Results: The results indicate very low values of energy Eoff dissipated in the turn-off process of the transistors under consideration, even at a drain current of approx. 20A. Measurement results shows the scale of the error of measurements of energy dissipated in the MOSFET turn-off transient when using oscilloscope measurements. Conclusions: The results provided in the paper confirm good metrological properties of the proposed by authors thermovision method employed in the study for the determination of energy losses in converters with very high energy efficiency.
Authors and Affiliations
Piotr Grzejszczak, Roman Barlik
AN ARTIFICIAL NEURAL NETWORKS APPROACH TO STATOR CURRENT SENSOR FAULTS DETECTION FOR DTC-SVM STRUCTURE
Background: During last few years, fault-tolerant control systems (FTCS) [1] for electric motor drives became a very active research field for many research groups. The proper choice of the fault tolerant control algorit...
Application of Super-Twisting Sliding Mode Controllers in Direct Field-Oriented Control System of Six-Phase Induction Motor: Experimental Studies
This paper presents the direct field-oriented control (DFOC) method of six-phase induction motor with the application of super-twisting sliding mode algorithm. The mathematical model of the six-phase induction motor has...
Effects of Grid Disturbances on Current Source Rectifier Controlled by FCS-MPC Algorithm
Nowadays, the increasing number of non-linear loads influences the grid, causing grid voltage disturbances. These disturbances may be very dangerous for the equipment and can create faults in converter behaviour. However...
Performance and Stability Analysis of Series Cascaded High gain Interleaved Boost Converter for Photovoltaic applications
Interleaved boost converters (IBC) are cascaded with more numbers in parallel for most of the applications. A novel approach is attempted to connect IBC in series cascaded. The maximum advantage of IBC has when it is ope...
PMSM Servo-Drive Fed by SiC MOSFETs Based VSI
The article presents modern PMSM servo-drive with SiC MOSFETs power devices and microprocessor with ARM Cortex core. The high switching frequency is obtained due to the application of high efficient power switching compo...