The Effect of Cutting Parameters on Machinability in Turning of Duplex 1.4462 Stainless Steels
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2017, Vol 5, Issue 3
Abstract
In this study, effects of cutting parameters and cutting tool formation on machinability were examined in Dublex 1.4462 stainless steel in turning which is increasingly used due to its high mechanical properties. Experiments were carried out at constant cutting speed (80 m / min), two different feeds (0.225-0.3 mm / rev) and three different cutting depths (0.75-1-1.25 mm). In cutting experiments, trade grade SNMG120408-QM and SNMG120408-SMR PVD 1105 TiAlN coated carbide cutting tools were used. As a result of the tests performed, the best results were obtained with a cutting depth of 0,75 mm, a feed rate of 0.225, and a SMR chip form in terms of the average cutting force and the average roughness of the surface.
Authors and Affiliations
Ahmet MAVİ, Gültekin UZUN
Keywords
Related Articles
- EP ID EP484346
- DOI -
- Views 92
- Downloads 0
Investigation of Single Bolted Connections of Thin Wall U Steel Profiles with Eccentric Behaviour
There is no Turkish standard for bolted connections of thin walled steel elements. In the calculations made according to Eurocode and AISI standards, there are different approaches and behaviours for the same sample. The...
The Determination of the Phase Transformations and the Activation Energies in TiNi Smart Alloys
In this study, the phase transformation characteristics of a Ti50,1Ni49,9 (% at.) alloy were investigated through Dynamic Scanning Calorimetry technique with various heating/cooling rates and the effects of the heating/c...
Determination of the Active Power Filter Type Based on the Component to be Compensated
Power converters affected by nonlinear loads cause the current from the grid. Because of this harmonic distortion current and voltage wave forms of grid becomes sum of the fundamental component and other sinusoidal compo...
Fabrication of Metal/Ferro-Electric/Semiconductor (Au/Bi4Ti3O12/n-Si) Devices and Temperature Dependent Examination of Their Complex Dielectric and Electric Modulus at 1 MHz
Metal-semiconductor (MS) devices, which have ferroelectric (Bi4Ti3O12) interfacial layers, were fabricated and their complex dielectric (*='-j") and electric modules (M*=M'+jM") have been studied in a wide range of t...
Measurement and Calculation of Breakdown Voltages in CF4 Gas Mixtures
Tetrafluoromethane (CF4) has found industrial applications in power switching and gas insulated circuit breakers although it is considered to be a powerful greenhouse gas. This disadvantage can be overcome by mixing CF4...