The Effect of Explosıve Ratıo on Interface Formatıon in Explosıon Weldıng of Non Alloyed and Austenıtıc Steel Plates
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2017, Vol 5, Issue 3
Abstract
In this study, weldability of austenitic stainless steel sheet to DKP sheet metals by explosive welding and the effect of explosive ratio (Elbar 5) on the joint interface have been investigated experimentally. Experimental results show that austenitic stainless steel can be bonded to DKP sheet by using explosive bonding. The joint interface was transformed from line ar to wavy appearance within increasing explosive ratio with respect to upper plate weight. Moreover, with increasing explosive ratio, the wavelength and amplitude of waviness increased. Hardness measure indicate that the impact force leads to increase in hardness of the zone next to interface and outer surface of the plates.
Authors and Affiliations
Mehmet Serkan YILDIRIM, Ahmet DURGUTLU
Keywords
Related Articles
- EP ID EP484370
- DOI -
- Views 76
- Downloads 0
Z in ’Sequential Model’ Spin Analysis for New Adjustment
In the e + e multiplier, the spin analysis for the Z boz new tuning boson was studied. In the Sequential Model, a normalized cross-section of different spin states was investigated. This study shows that the new setting...
Effect of Cutter Width on Shear Force during Grooving
In this paper contains the determination of the cutting forces with experimental measurements according to the variations in the cutting parameters during grooving operation to the outer surface and the effect of the ins...
Design and Implementation of Automation System for Water Leakage Test in Vehicle
In this study, design and implementation of automation system for water leakage test, which is one of the quality control tests, in vehicle is explained in detail in order to ensure continuous operation and without inter...
Reliability Analysis of A Cantilever Beam with Circular Hole Depending on Stress-Concentration Factor By Using Monte Carlo Simulation Method
Stress-concentration factor (SCF) is known to be the ratio of the maximum experimental stress around the sudden change of the geometric shape to the theoretical nominal or reference stress. Recently, the investigation of...
Functionally Graded Porous Implants Obtained by Additive Manufacturing
Porous structures have an increasing use in the biomedical industry due to their advantage, such as supporting tissue regeneration for implants and prostheses used in the body, eliminating stress shielding and aseptic lo...