The Finite Element Analysis of High Precision Positioning System
Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2018, Vol 68, Issue 4
Abstract
The paper deals with design and computation of precise positioning mechanism. The aim of mechanism is to transfer applied load without any change of position of parts in question. The stabilization of position is assured by elastic elements connected to reductor which is adjusted into correct position by an actuator. The functionality of mechanism and its stiffness and strength characteristics were checked by the finite element method. The computations were accomplished for prescribed displacement of reductor. On the base of this type of loading the behaviour of the structure was evaluated.
Authors and Affiliations
Trebuňa František, Bocko Jozef, Pástor Miroslav, Lengvarský Pavol and Prada Erik
Keywords
Related Articles
- EP ID EP43967
- DOI https://doi.org/10.2478/scjme-2018-0045
- Views 201
- Downloads 0
The Calculation of the Contact Force and the Contact Width of Shaft Seals
The aim of the article is to point out the sealing efficiency of the two-language seal of the water pump bearing when radially deflecting the shaft within radial clearance. In order to obtain a radial displacement of th...
Investigation of Defect Effects on Adhesively Bonded Joint Strength Using Cohesive Zone Modeling
In this paper, effects of the defect in an adhesively bonded joint have been investigated using cohesive zone modeling. Consequently, a 3D finite element model of a single lap-joint is constructed and validated with ex...
Parametric Study for Wire Cut Electrical Discharge Machining of Sintered Titanium
In 21st century, it has been observed that Wire Cut Electrical Discharge Machining (WEDM) has evolved as one of the most important non-traditional machining process. The popularity and its success lies because of its u...
Fem Simulation of Thermal Cycles During Laser Welding of Aluminium
The submitted paper deals with the simulation of thermal cycles during laser welding of aluminum sheets using Finite Element Method (FEM). After the design and creation of the simulation model, the simulation results w...
Thermo-Hydraulic Behaviour of Coolant in Nuclear Reactor VVER-440 Under Refuelling Conditions
The paper presents the numerical simulation of thermo-hydraulic behaviour of coolant in the VVER- 440 nuclear reactor under standard outage conditions. Heating-up and flow of coolant between the reactor pressure vessel...