The influence of sigma phase on erosion and corrosion properties of duplex steel
Journal Title: Archiwum Odlewnictwa - Year 2010, Vol 10, Issue 3
Abstract
The paper presents the results of investigations concerning the influence of σ phase precipitating on the erosion and corrosion properties of ferritic-austenitic cast steel. The object of investigation have been two grades of corrosion-resistant cast steel: GX2CrNiMoCuN25-6-3-3 and GX2CrNiMoN25-6-3. The examinations have involved measurements for obtaining potentiodynamic curves, examination of erosion and corrosion resistance, and microstructural analysis. The supersaturated cast steel and the material after heat treatment have been examined. It has been found that the tribological properties of supersaturated cast steel are worse than those of the supersaturated and annealed cast steel. The highest erosion and corrosion resistance has been achieved as a result of ferrite decomposition δ → γ’+ σ. The examinations of corrosion resistance have revealed that the ageing process after supersaturation do not cause significant changes in the anti-corrosive properties.
Authors and Affiliations
Z. Stradomski, A. Brodziak
Keywords
Related Articles
- EP ID EP72139
- DOI -
- Views 78
- Downloads 0
Ferritic-austenitic cast steel - selected problems
The author has been involved in the problems occurring in the manufacture of ferritic-austenitic cast steel castings for many years. The author’s remarks and investigation results reported in this article will enable pot...
The structure of Ni–enriched Al–Ni molten alloy before solidification
The structure of Ni–based molten alloy, containing 88,02w.%Ni and dopped both with Zr (0,46w.%) and B (0,02w.%) has been studied by means of X–ray diffraction method at temperature 1500 K. Structure factor and pair corre...
An attempt of assessing the production perspectives concerning malleable iron castings
The paper presents a historical outline of production of the malleable cast iron castings on the territory of Poland during the past over a hundred years. There have been also gathered data concerning the total quantity...
Silumins alloy crystallization
This paper presents the results of research, by ATD method, of hypo-, near- and hyperutectic silumins crystallization containing the following alloying additives: Mg, Ni, Cu, Cr, Mo, W, V. It has been shown that, dependi...
Research on possibility of microwave measurements application for determination of adhesive ingredient content in moulding sand
This paper presents preliminary results of the research on possibility of determination of adhesive material content in classical moulding sands with application of microwave measurements. Presented results have been obt...