THE INFLUENCE OF THE LAYERED STRUCTURE OF POLYMER COATINGS ON THEIR EROSIVE RESISTANCE
Journal Title: Tribologia - Year 2017, Vol 272, Issue 2
Abstract
The paper presents the results of erosive resistance investigation of three-layer epoxy coating systems with different compositions of surface layers. This layer was modified with glass microspheres or nanoparticles of aluminium trioxide or silica. The highest erosive resistance, in the whole thickness range of examined epoxy coatings, was revealed by coating systems with a surface layer (top coat) modified using nanoparticles of aluminium trioxide. Similar but slightly lower erosive resistance was reported in the case of surface layer modification with nanoparticles of silica use. High erosive resistance of coating systems modified with nanoparticles results from their structure reinforcement by nanoparticles that seal nanopores generated during the process of coating constitution. The lowest erosive resistance was observed in the case of systems with a surface layer modified using glass microspheres. This results from high brittleness of glass microspheres, which is evident during the coating surface bombardment with alundum particles. The paper demonstrates the methods for the analysis of the interaction between lubricant and steel substrate and presents the obtained results. The samples to be tested were commercially available greases as well as greases developed for the purpose of this research, containing a known amount of adhesion additives. Due to the lack of normalized methods, the authors applied indirect methods based on the analysis of the peel resistance and the resistance to variable shearing rates. The obtained results reveal that there is a possibility to apply the proposed methods for the comparative assessment of interactions between the grease and steel substrate.<br/><br/>
Authors and Affiliations
Danuta KOTNAROWSKA
Keywords
Related Articles
- EP ID EP240855
- DOI 10.5604/01.3001.0010.6305
- Views 93
- Downloads 0
BADANIA TRIBOLOGICZNE NANOMATERIAŁÓW DO ODBUDOWY ZĘBÓW TRZONOWYCH I PRZEDTRZONOWYCH METODĄ BEZPOŚREDNIĄ
Fizjologiczne starcie zębów jest to proces stopniowej utraty twardych tkanek zębów przeciwstawnych w wyniku naturalnego zużycia postępującego z wiekiem. Starcie to polega na jednoczesnym spłaszczaniu guzków i ich stoków...
TRIBOLOGICAL PROPERTIES OF VEGETABLE OILS AS POTENTIAL LUBRICANT BASES
The paper presents the test results of the antiwear and extreme-pressure properties of vegetable oils. They were compared to mineral machine oil L-AN 46 without additives. Wear scars were analysed during tribological exa...
APPLICATION OF THE CENTRAL COMPOSITE ROTATABLE DESIGN IN THE OPTIMISATION OF PARAMETERS OF A BALL-CRATERING METHOD
This article presents an outline of a method of planning an experiment known as the central composite rotatable design (CCRD) for the optimisation of processes and as an example of its application in the optimisation of...
INNOWACYJNA TECHNOLOGIA WYTWARZANIA WARSTW PRZECIWZUŻYCIOWYCH NA NARZĘDZIA DO KUCIA NA ZIMNO
Narzędzia do kucia na zimno poddawane są bardzo dużym obciążeniom ze względu na wysokie naprężenia oraz umocnienie podczas kształtowania. W niniejszym artykule przedstawiono analizę wpływu zmiany powierzchni narzędzi z t...
THE EFFECT OF OIL POCKET ARRAYS ON FRICTION COEFFICIENT
Experiments were carried out using pin-on-disc tester in conformal lubricated contact conditions for different normal loads. Surface texturing was done using abrasive jet machining with the application of laser cut mask....