The phenomena occurring along borderline of the phase shares in the casted Al-Al2O3 composites
Journal Title: Archiwum Odlewnictwa - Year 2009, Vol 9, Issue 2
Abstract
In the foregoing work, one analyses in detail the use of nickel cover on the Al2O3 particles in composites with the Al matrix (Al alloy). The mechanisms of developing the Al-Ni combination on the interface were the subject of the detailed analysis. The aim of the work was to present the model research, the aim of which is to describe mechanism of the combination in the sphere of aluminum-nickel sphere, in gradient. The research of the combination between the above mentioned metals was conducted in gradient of the heating temperature lower than the melting temperature of aluminum and in the time of parch. One observed visible changes in the structure and chemical composition on the butt of those metals, caused by the concentration diffusion mechanisms. Moreover, in the temperature of 640oC in the time of 48 hours, one observed the Frenkel pores.
Authors and Affiliations
K. Garbala, A. Patejuk
Keywords
Related Articles
- EP ID EP70537
- DOI -
- Views 126
- Downloads 0
Selected characteristic of silumins with additives of Ni, Cu, Cr, Mo, W and V
The study, presents an investigation results of new grades of silumins containing of: 7,0÷17,0% Si, 4,0% Ni, 4,0% Cu and 0,5% Cr, Mo, W each as well as V. The influence tests were carried out of - antimony addition, stro...
Casting Ductile Iron in Layer Moulds Made from Ecological Sands
The article contains the results of tests performed under the target project in Hardtop Foundry Charsznica. The objective of the tests and studies was to develop a technology of making high-quality ductile iron castings,...
Geometrical and mechanical analysis of 3D casted skeleton structure
The article presents selection of the geometry of engineering casted skeleton structure using the analysis of the stress state of structural variants. The main criterion for selection was using the simplest geometry of c...
The dimensional and shape accuracy of vacuum castings prepared in plaster moulds
The results of laboratory test on the dimensional and shape accuracy of bronze plaster castings CuSn10, CuSn5Zn5Pb5and AlSi11 silumin are presented in this paper. The test castings were made in form of rods of length 100...
The influence of sigma phase on erosion and corrosion properties of duplex steel
The paper presents the results of investigations concerning the influence of σ phase precipitating on the erosion and corrosion properties of ferritic-austenitic cast steel. The object of investigation have been two grad...