THE WEAR PROCESS OF IMPACT MILL WORKING ELEMENTS AND WAYS OF MINIMIZING THE CONSEQUENCES OF THIS PROCESS
Journal Title: Tribologia - Year 2015, Vol 261, Issue 3
Abstract
The paper presents an analysis of the factors affecting the intensity of the wear process of impact disk-pin mill, mainly its working parts – pins. Structural factors have been identified which were the following: the area of the pins’ surface and the state of the surface layer. On this basis, the following design changes were made: Threads were cut into side surface of the pins increasing their active surfaces by approx. 80%. The pins were also thermo-chemical treated – nitriding. The application of proposed changes has nearly doubled the durability of the pins.<br/><br/>
Authors and Affiliations
Michał STYP-REKOWSKI, Zbigniew BOROWSKI, Józef FLIZIKOWSKI, Maciej MATUSZEWSKI
Keywords
Related Articles
- EP ID EP258052
- DOI -
- Views 47
- Downloads 0
Analiza teoretyczno-eksperymentalna zmienności siły osiowej w połączeniach śrubowych
Przedstawiono dwie analizy rozrzutu wartości zacisku wstępnego w śrubie podczas montażu połączeń śrubowych. Analiza teoretyczna oparta jest na zmienności współczynnika tarcia, nawet dla tego samego rodzaju materiału śrub...
Analiza właściwości glebowej masy ściernej w aspekcie oddziaływania zużyciowego
Przedstawiono wyniki badania wpływu właściwości glebowej masy ściernej na zużycie stali 38 GSA, powszechnie stosowanej na elementy robocze obrabiające glebę. Właściwości masy ściernej scharakteryzowano składem granulomet...
PRESSURE AND VELOCITY DISTRIBUTION IN A SLIDE JOURNAL BEARING GAP BY LAMINAR UNSTEADY LUBRICATION
This paper shows the results of numerical solutions of modified Reynolds equations for laminar unsteady oil flow in the slide journal-bearing gap. Laminar unsteady oil flow is performed during periodic and non-periodic p...
ANALYSIS OF FRACTURE AND WEAR RESISTANCE OF ZrN COATINGS
The article presents the results of mechanical and tribological studies of ZrN coatings that allowed the determination of their hardness, elasticity modulus, and scratch and wear resistance. Tests were carried out for 1,...
TOPOGRAPHY OF ROLLING BEARINGS COOPERATING SURFACES MEASURED WITH AN ATOMIC FORCE MICROSCOPE
In this paper authors present measurements results of the surface topography of the cooperating surfaces of rolling bearings conducted with an atomic force microscope (AFM). Measurements of surface topography were made f...