Thermal analysis and microstructure of master alloys used for modification of silumins
Journal Title: Archiwum Odlewnictwa - Year 2009, Vol 9, Issue 3
Abstract
The study presents the technological backgrounds of the process of melting and casting Al-Co, Al-Ni, and Al-Ti master alloys, used as refiners of the microstructure of cast silumins. Basing on the analysis of phase equilibrium diagrams for an Al-Me (Co, Ni, Ti) system at a temperature of 900oC, the characteristic intermetallic phases of AlxMey were investigated. Due to their similarity with Al and Si in respect of both structure and lattice arrangement, these phases may act as heterogeneous nuclei and promote solution hardening during, e.g., heat treatment. Using the method of thermal analysis ATD, the temperature was plotted in function of time, and then the characteristic values of the solidification parameters of master alloys were read out from the respective curves.
Authors and Affiliations
J. PiÄ…tkowski
Influence of parameters GTAW remelting process on the tribological properties of the 100Cr6 bearing steel
In this work, the influence of parameters gas tungsten arc welding on the surface properties of a 100Cr6 steel was studied. Four different the current intensity has been used to remelting surface of the steel. Results of...
Heat treatment of the EN AC-AlSi9Cu3(Fe) alloy
Silumins are widely used in automotive, aviation and shipbuilding industries; as having specific gravity nearly three times lower than specific gravity of cast iron the silumins can be characterized by high mechanical p...
Three-dimensional numerical model of solidification with motion of the liquid phase
The paper presents numerical modeling of solidification process with convective motion of the liquid phase, generated both in the liquid and mushy zones. The transition region between the areas filled with liquid and sol...
Friction wear cast iron casting surface hardened by concentrated source of heat
In this study surface fusion by the GTAW (in argon atmosphere) surfacing process on plate of cast iron with electric arc advance speeds from 200 to 800 mm/min and current range I=300A were performed. The geometry, micros...
Analysis of the influence oxygen and hydrogen during melting aluminium and his alloys
In the work was stated term the analysis of ion influences in melting codnuction of aluminium and his alloys. Influence from hydrogen and oxygen, hydrogen and oxygen and steam water together was distinguished. Where have...