Influence of parameters GTAW remelting process on the tribological properties of the 100Cr6 bearing steel
Journal Title: Archiwum Odlewnictwa - Year 2011, Vol 11, Issue 3
Abstract
In this work, the influence of parameters gas tungsten arc welding on the surface properties of a 100Cr6 steel was studied. Four different the current intensity has been used to remelting surface of the steel. Results of the effect of the current intensity arc electric on the microhardness, friction coefficient and wear intensity 100Cr6 steel was presented. Wear mechanisms were investigated by optical and scanning electron microscopy. Tribological test showed that the remelting with current intensity to 60A surface of the 100Cr6 leads to reduction of wear intensity in comparison to the conventional heat treatment. If treatment was made with current arc intensity - 80 A and more the wear intensity increased. During tribology tests two kinds wear material were distinguished: abrasive wear and adhesive wear.
Authors and Affiliations
W. Bochnowski
Keywords
Related Articles
- EP ID EP72292
- DOI -
- Views 136
- Downloads 0
Interactions at the mould – modifying coating – molten nickel alloy interface
The study describes thermal-chemical interactions that take place in the molten nickel alloy-ceramic mould system, where the mould is either coated with a modifying coating („blue” mould) or is not („white” mould). The c...
The attempt at evaluation of the ADI microstructure with the use of the image analysis
In this work the attempt at quantitative evaluation of the microstructure of ADI cast iron matrix has been made. The automatic analysis of the image of the microstructure of austempered spheroidal cast iron has been used...
Measurement of large-size casting geometry of the CMM
The aim of this paper is to present the geometric dimensions’ control of large castings and moulds on coordinate measuring machines (CMMs). Precise measurements of large components are connected with many problems that a...
Effect of thickness of refractory coating on the Lost Foam Process
The analysis of the influence of the thickness of refractory coating on the production process of casts in the Lost Foam process was introduced in the work. It was conducted in the peculiarity the analysis simulating inv...
TDA method application to austenite transformation in nodular cast iron with carbides assessment
In this paper the possibility of TDA method using to austenite transformation in nodular cast iron with carbides assessment is presented. Studies were conducted on cast iron with about 2% molybdenum and 0,70% to 4,50% ni...