Thermostressed State of the Lock Joint of Turbine Rotor Blades of the First Stage of К-500-240 Steam Turbine Medium Pressure Cylinder
Journal Title: Проблеми машинобудування - Year 2019, Vol 22, Issue 3
Abstract
This paper investigates the temperature field effect on the stress state of the turbine rotor blade lock joint elements where breakdowns were observed. The turbine rotor blade joint, when heat is supplied from the steam flow, is in conditions of uneven heating. In this case, the physico-mechanical properties of materials change, and one can observe gradients of the temperature causing unequal thermal expansion of individual parts of the structure. This leads to temperature stresses, which, in combination with mechanical stresses from external loads, can cause significant plastic deformation of the structure, cracks, or damage to structures. To clarify the distribution of structural stresses in the lock joint structure, a problem is solved taking into account the temperature field. The problem is solved in a thermal contact setting, with taking into account the heat transfer influence on the transfer of forces in the lock joint. The contact interaction problem is essentially nonlinear, and the temperature problem is connected with the mechanics problem through previously unknown boundary conditions in the contact. The stress state and the nature of the contact interaction depend on the temperature field, which is determined by interaction conditions. The solution to the thermal contact problem in the lock joint is based on the application of the contact layer model. Zones of expected contact interaction are represented by contact elements. The mechanical interaction of contact surfaces is determined by their mutual penetration. The problem is solved using the finite element method, the total number of elements being 371 498. In this model, there are several zones of contact interaction: namely, the area of contact of the pins with the disk, as well as with the locking blade and adjacent blades; the area of contact of the pressure pads of the roots of adjacent blades and the disk shaft end. In the contact zones, the mesh is thickened. The calculation results are presented in the form of the temperature distribution over the lock joint. It is shown that there is a temperature drop along the radius and width of the disk. The temperature of 533 °С from the side of the steam inlet drops to the level of 525 °С from the side of the steam outlet. Results of the calculated assessment of the stress state of the lock joint of turbine rotor blades are given for the first stage of the medium pressure cylinder of a steam turbine. These results indicate significant stresses that can cause plastic deformation.
Authors and Affiliations
Ihor A. Palkov, Mykola H. Shulzhenko
Keywords
Related Articles
- EP ID EP641635
- DOI 10.15407/pmach2019.03.036
- Views 78
- Downloads 0
Solution of the Structural Optimization Problem of a Multiagent Approach Based Cutter Design
This article proposes a decision support system project to find the optimal milling cutter design. At the preliminary design stage, morphological analysis is used. It allows us to find and systematize all possible millin...
Translational Wave Impact on the Operation of the Dniester Pumped Storage Power Plant Upper Reservoir
The role of hydraulic energy as a reliable source of renewable energy to meet the ever-growing needs of society is highlighted. The uneven nature of the energy supply during the day is analyzed. The role of hydroelectric...
Packing convex homothetic polytopes into a cuboid
This paper deals with the optimization problem of packing a given set of homothetical arbitrarily oriented convex polytopes without their overlapping in a linear parallelepiped of minimal volume. Phi-functions are propos...
Heat Transfer During Subcooled Boiling in Tubes (A Review)
This article provides a review of the correlations and models for determining the intensity of heat transfer during subcooled boiling in pipes. As a rule, correlations are based on dimensionless similarity numbers, while...
Analytical Method of Profiling Axial-Radial Compressor Impellers
A new analytical method for constructing axial-radial compressor impellers with compound lean leading and trailing edges is proposed allowing us to describe a wide class of flow paths based on a limited (small) number of...