Two-part electrodes of the physical phantom for EIT
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2017, Vol 0, Issue 70
Abstract
In this article explored methods for increasing of the accuracy of measurement in the hardware part of the electrical impedance tomograph, in particular, in its electrode system, which contains two-parts (combined) electrodes and are installed directly in a physical phantom. The principles of construction of the measuring part of the EITomograph using simple and combined electric drives are considered. Justified the choice of material for the producing of electrodes. Presented the construction of combined electrodes and the parameters of different materials for their producing. In the article describe the influence of non-identity for physical sizes of combined electrodes. Shown possible variants for the compensation of inaccuracy in the producing of electrodes and the inaccuracy of their installation. Increased ease of use and maintainability signal transmission lines by using these electrodes. Compared to simple electrodes, combined have several advantages: maintainability; rapid replacement of the electrode in a physical phantom (even in the presence of an electrolyte); manufacturability of producing; higher mechanical resistance and reliability; absolute decoupling of the measuring circle and power circle in the hardware part of the EITomograph; significantly lower amount of occurrence of artifacts during the image reconstruction. That's why application of combined electrodes leads not only to facilitate the physical construction and setting of the EITomograph. It also increases the quality of the solution of the inverse problem.
Authors and Affiliations
O. Hamanenko, E. Guseva
Keywords
Related Articles
- EP ID EP308208
- DOI 10.20535/RADAP.2017.70.49-55
- Views 62
- Downloads 0
Modeling of microstrip analogue of a photon crystal
The comparative modeling of microstrip analogue of a photon crystal by an impedance method, diner’s method and method of final integrals is considered. The characteristics which show mutual conformity of results are give...
Filtration of weak signals in white Gaussian noise
Introduction. The level of desired signals, in some cases, is comparable to the level of in-trinsic noise source in radio and electronic systems. It creates substantial difficulties in the processing of these signals. Th...
Own waves in a transversely inhomogeneous open cylindrical dielectric waveguide
By the point matching method, taking into account only the even electric longitudinal field components, is considered the eigenvalue problem – constant propagation in inhomogeneous dielectric waveguide. The following mod...
Evaluation of efficiency of the fault-tolerant systems with reconfiguration of the core of majority structure
Models of fault-tolerant system with a combined structural redundancy, which includes the majority structure with N- th number of technical systems in the core and their sliding redundancy are presented. Exploitation of...
The Influence of Neutron Radiation on Characteristics of the Heterostructures with Red and Yellow Emission Color
A research of influence of neutron radiation on the characteristics of heterostructures (AIxGa1-x)0.5In0.5P was carried out. The received results of experiment that allow us to predict the degradation of characteristics...