Updated Assessment of Joint Work of Thin-Sheet Membrane Coating with a Reinforcing Element
Journal Title: Металлические конструкции - Year 2018, Vol 24, Issue 3
Abstract
In the article it has been considered the technique of determination of effective flange width of I-beam used in conjunction with sheet membrane coating, including on the basis of the computation of the reduction coefficients. The applicability to the solution of this problem of the approaches described in the works of P. F. Papkovich and the norms of the Eurocode (part 1.5) has been analyzed, where the joint work of the thin-sheet membrane coating and the reinforcing element under the action of the distributed load has been considered as the object of research. The results obtained using analytical methods of the solution are supplemented by finite element analysis of the inclusion of a thin-sheet membrane plate in the joint work with the I-beam element for transverse bending, the simulation of which was carried out using shell elements in a geometrically nonlinear formulation. Obtained results allow us on the basis of refined approaches to estimate the size of the membrane plate area involved in the joint work on the transverse bending with a reinforcing element.
Authors and Affiliations
Volodymyr Mushchanov, Vladimir Shpinkov
Keywords
Related Articles
- EP ID EP536621
- DOI -
- Views 93
- Downloads 0
The Model Tests of Vertical Cylindrical Tanks and a Verification of Numerical Researches
This article discusses the results of model tests for vertical cylindrical tanks of 20 thousand m3. Since the loads were sufficiently studied for structures with an aspect ratio of height to width ratio of less than 0.5...
Accounting of Constructive Features Nodes Compound Based Stable Central Compressed Rods Structural Coverage
In the article the results of research of influence of constructive decisions of nodal connections of structural designs on the critical forces and form of buckling failure by center-compression element of covering have...
Rational structural decisions load-bearing supporting structures dome diameter 15 m
Based on a critical analysis of the experience of the design and construction of domes, the most common designs bearing dome structures have been determined. The calculation of the domes and the analysis of the stress an...
Metal multifaceted poles as a base of the urban infrastructures
The article deals with national and the foreign experience of metal multifaceted bent conical poles (tubes) at creation of tower structures directed to a providing of livelihood needs of modern cities. The analytic revie...
A Determination of the Residual Life of Steel Bin of Coke-Screening Station Taking into Account Operating Corrosive Damages
The article presents the results of analysis of the tensely-deformed state of a steel bunker for storage of coke. The calculation is performed according to engineering procedure and using software complex LIRA-SAPR 2013....