VIBRATION DIAGNOSTICS AS A METHOD OF SUPPORT FOR OIL TO LUBRICATE A TOOTHED GEAR
Journal Title: Tribologia - Year 2011, Vol 239, Issue 5
Abstract
The paper presents the problem of supporting the selection of optimum viscosity grade lubricating oil to the cylindrical gear by using vibration analysis. For power plants operating with a conveyor belt drive system with a hine oil lubricated gearbox with too low viscosity grade (ISO VG 46) casing vibration measurements by stating their elevated levels were made at selected points. Therefore the use of gear oil of viscosity grade VG 150 was proposed, that as research results showed, reduced the amplitude (and therefore the noise) generated by the transmission, and reduced the oil temperature about 15%. Presented a practical example documents the possibility of using vibration diagnosis as a method of support in the process of optimising the selection of oil for the lubrication industrial toothed gears.
Authors and Affiliations
Seweryn Spałek, Maciej Kwaśny, Jacek Spałek
Keywords
Related Articles
- EP ID EP271020
- DOI -
- Views 48
- Downloads 0
IMAGE-BASED ANALYSIS OF WEAR STATE OF CERAMIC NITRIDE CUTTING TOOLS AFTER MACHINING OF NODULAR CAST IRON
This paper presents the results of the wear of nitride ceramic tools, uncoated and coated with CVD-Al2O3/TiN layer, in the machining of pearlitic-ferritic nodular cast iron-EN-GJS-500 grade. Investigations include the to...
THERMOELASTIC ANALYSIS OF MULTI-DISC CLUTCHES USING FINITE ELEMENT METHOD
The high thermal stresses generated between the contacting surfaces of a multidisc clutch system (pressure plate, clutch discs, plate separators, and piston) due to the frictional heating generated during slipping are co...
THE EFFECT OF OIL POCKETS ON THE SEIZURE OF A FRICTIONAL PAIR: STEEL–BRONZE
The paper shows the examples of cylindrical surfaces with oil pockets created in Rzeszów University of Technology, Department of Manufacturing Processes and Production Organisation. Possibilities of improvement in seizur...
INTERACTION BETWEEN THE CREATION OF A WHITE LAYER AND ADHESIVE REACTION IN CASE OF FRICTION OF ALLOY IRON IN HIGH TEMPERATURE
The work characterizes the phenomenon of the formation of the “white layer” on the surface of tools used for the hot forming process of steel. It describes the structural factors of iron alloy tools that favour plastical...
Zagadnienia cieplne w mechanizmie sprzężenia elementów tocznych
W pracy przedstawiono mechanizm sprzężenia elementów tocznych uwzględniający poślizgi geometryczne, sprężyste oraz poślizgi wynikające z odkształceń plastycznych w miejscach rzeczywistego styku. Ponadto uwzględniono: róż...