Vickers Hardness of Composite Resins Cured with LED and QTH Units
Journal Title: Journal of Dental Biomaterials - Year 2016, Vol 3, Issue 1
Abstract
Statement of Problem: One of the factors affecting the degree of polymerization of light-cured composites is the type of light-curing unit used. In addition, physicomechanical properties of the composite resins depend on the degree of conversion and polymerization. Objectives: Since the type of initiator in new composite resins is not explained by manufacturers, this study is an attempt to compare the depth of hardening, with two LED and QTH light-curing units. Materials and Methods: Fifteen samples prepared from Gradia Direct and Filtek Z250, both of which being universal, were cured with QTH (Astralis 7) and LED (Bluephase C8) light-curing units. All the samples were molded in polyester resin and cut from the middle by a disk. The hardness of the cut area was evaluated at 0, 0.5, 1, 1.5, 2, 2.5, 3, 3.5 and 4-mm depth intervals and also at the same interval as the width of the sample, with Vickers hardness machine, while the sam- ples were placed in a darkroom. Data were statistically analyzed using one-way ANOVA, two-way ANOVA, t-test and post Hoc Tukey’s tests in SPSS, version 16. Results: Filtek Z250 was harder than Gradia Direct at all the depth with both light-curing units. The hardness of Filtek Z250 sample cured with Astralis 7 was higher than that cured with LED, but with Gradia Direct the LED unit resulted in higher hardness. Curing depth was not significantly different between the groups (p = 0.109). Conclusions: Vickers hardness number for both composites used in this study is in an acceptable range for clinical implications. The composites’ composition is important to be considered for selection of light unit. Based on the findings of the present study, LED did not present more curing depth compared with QTH.
Authors and Affiliations
H Alaghemand, M Ramezani, N Zarenejad
Keywords
Related Articles
- EP ID EP248717
- DOI -
- Views 68
- Downloads 0
Novel User-friendly Device for Human Bite Force Measurement
Statement of Problem: Bite force is generated due to the consonance between different parts of the masticatory system. In dentistry, measurement of the bite force is quite common through several methods and devices. Obje...
The Effect of Time Intervals on Heat Transfer to the Implant-Bone Interface during Preparation of a Titanium Abutment: An in Vitro Study
Statement of Problem: Thermal injury during dental implant placement and restoration is a clinical concern as it may cause bone damage and compromise osseointegration. The threshold level for heat-induced cortical bone n...
Comparison of Mechanical Properties Between three Different Types of T-loop
Statement of Problem: T-loop is one of the most popular closing loops in orthodontic profession. However its activation is in the contrary to Bouschinger effect theory, since the formed bends would be opened during activ...
Wear Resistance of Acrylic Resin Teeth against Porcelain and Natural Teeth
Statement of Problem: The effect of porcelain surface on the antagonist acrylic teeth has not been widely studied. Objectives: This study aimed to investigate the effect of polished porcelain, glazed porcelain, and natur...
Recent Advances and Future Perspectives for Reinforcement of Poly(methyl methacrylate) Denture Base Materials: A Literature Review
Poly(methyl methacrylate) (PMMA) is the most common material used to fabricate complete and partial dentures. Despite its desirable properties, it cannot fulfill all mechanical requirements of prosthesis. Flexural fatigu...