Wear Behavior of Materials Based on Cu/Cr and Cu/Cr/W used for Welding Electrodes
Journal Title: Tribology in Industry - Year 2014, Vol 36, Issue 4
Abstract
The paper presents experimental research regarding the wear behavior of some composite materials based on Cu/Cr and Cu/Cr/W prepared by Powder Metallurgy (PM) route. Because of low solubility between Cu and Cr is very difficult to elaborate these types of materials by classical technologies and because of that, in this research was used Mechanical Alloying (MA) technique to prepare Cu/Cr materials. In order to obtain good refractory was introduced 5% of W in the mass of materials. There were made studies regarding the wear behavior of these materials function the Cr content.
Authors and Affiliations
C. Nicolicescu , M. Miclău , V. H. Nicoară
Keywords
Related Articles
- EP ID EP121815
- DOI -
- Views 104
- Downloads 0
Tribological Characterisation of PBT + Glass Bead Composites with the Help of Block-on-Ring Test
The materials involved in this research study were produced by die moulding in order to obtain bone samples type 1A (SR EN ISO 527‐ 2:2003). These composites have a matrix of polybutylene terephthalate (PBT) commercial g...
X-Ray Emission during Rubbing of MetalsX-Ray Emission during Rubbing of Metals
A good deal of work carried out in recent past has shown that the triboelectromagnetic radiation produced during peeling of a scotch tape, breaking rock sugar with a hammer, peeling of mica sheets etc. may extend even to...
Case Study: the Influence of Oil-based Friction Modifier Quantity on Tram Braking Distance and Noise
In the present study, the twin disc machine and the light rail system was employed in order to investigate the ability of oil-based friction modifier (FM) to optimize adhesion and to reduce noise. The risks associated wi...
New Universal Tribometer as Pin or Ball-on-Disc and Reciprocating Pin-on-Plate Types
The present paper contains a description of a new Universal Tribometer design which enables simulation of different contact and test types such as pin-on-disc, ball-on-disc and linear reciprocating tests. There are many...
Simulation of Contact Area and Pressure Dependence of Initial Surface Roughness for Cermet-Coated Discs Used in Disc Brakes
Friction, wear, and emission performance strongly depend on the contact pressure and area at the interface of the pad and disc. The contact situation at the pad-to-disc interface can be explained by the formation and des...