WHALE OPTIMIZED PID CONTROLLERS FOR LFC OF TWO AREA INTERCONNECTED THERMAL POWER PLANTS
Journal Title: ICTACT Journal on Microelectronics - Year 2018, Vol 3, Issue 4
Abstract
This paper elaborates the application of new nature inspired algorithm; ‘Whale Optimization Algorithm (WOA)’ in load frequency control of two area interconnected non-reheat thermal power plants. Two number of PID controllers have been considered in the investigated system and the parameters of the controllers have been tuned/optimized using WOA. The design problem has been formulated as the constrained optimization problem with upper and lower bounds of controller’s parameters. The integral of time multiplied absolute error (ITAE) has been taken as an objective function in the present work. The parameters of controllers (KP, KI, KD), minimum damping ratio (MDR), the values of performance indices (ITAE, ISTE, ISE, IAE), settling times and overshoots of ?f1, ?f2 and ?PTie have also been evaluated for the system under investigation using WOA. The simulation results include the dynamic responses of ?f1, ?f2 and ?PTie for different step load changes from 0.1p.u. to 0.5p.u in area 1 by keeping constant 0.1p.u. step load change in area 2. It has been observed that smooth and better dynamic responses with fewer oscillations, less settling times and less overshoots can be achieved for the system using WOA.
Authors and Affiliations
Bhatt R, Parmar G, Gupta R
DESIGN OF TWO DIMENSIONAL PHOTONIC CRYSTAL RING RESONATOR BASED DEMULTIPLEXER
In this paper, a Photonic Crystal Ring Resonator (PCRR) based demultiplexer is proposed and designed to drop four different channels. The proposed structure is consists of bus waveguide, dropping waveguide and butterfly...
WHALE OPTIMIZED PID CONTROLLERS FOR LFC OF TWO AREA INTERCONNECTED THERMAL POWER PLANTS
This paper elaborates the application of new nature inspired algorithm; ‘Whale Optimization Algorithm (WOA)’ in load frequency control of two area interconnected non-reheat thermal power plants. Two number of PID control...
PERFORMANCE ANALYSIS OF ADIABATIC TECHNIQUES USING FULL ADDER FOR EFFICIENT POWER DISSIPATION
Adiabatic circuits are low power circuits, which deals with reversible logic that it stores the power and gives it back again. Currently Several Adiabatic techniques have been adopted for efficient power dissipation. The...
LOW POWER RF SINGLE BALANCED MIXER WITH HIGH CONVERSION GAIN FOR ISM BAND APPLICATIONS
This paper involves the design and simulation of a single balanced down conversion mixer from a Gilbert cell mixer using a source degeneration inductor and folded structure in 65nm CMOS Technology. The proposed single ba...
DESIGN AND ANALYSIS OF PERFORATED SI-DIAPHRAGM BASED MEMS PRESSURE SENSOR FOR ENVIRONMENTAL APPLICATIONS
The design is advanced which is an intelligent of calculating the output responses of perforated Si-diaphragm pressure sensor as a behavior of pressure and which compare them to piezoresistive Si-diaphragm. The systemati...