Alternative Energy Source for Heating System of Woodworking Enterprise
Journal Title: Energy Engineering and Control Systems - Year 2018, Vol 4, Issue 1
Abstract
At woodworking enterprises, there is a large amount of wood waste the energy potential of which can be used as an alternative source of energy for the generation of heat energy at boiler houses. Gasification is one of the cheapest and environmentally friendly methods for processing organic wood waste and obtaining an additional source of energy. The process of gasification occurs when wood waste is heated to high temperatures in the presence of oxygen, which results in the generation of combustible gas. Producer gas should be used to save traditional energy sources in the generation of heat energy. This article discusses the design of the gasifier which is intended for utilization of wood waste from a wood-processing enterprise and the simultaneous generation of producer gas. Generted producer gas is used in a boiler-house of a wood-processing enterprise as an alternative source of energy for the preparation of the heating system coolant. The lower heat of generated producer gas combustion is established.
Authors and Affiliations
Olena Savchenko, Vasyl Zhelykh, Yurii Yurkevych, Khrystyna Kozak, Serhii Bahmet
Keywords
Related Articles
- EP ID EP308019
- DOI 10.23939/jeecs2018.01.027
- Views 71
- Downloads 0
Modern Wind Turbines Capacity Utilization in Real Conditions
The development of the national wind power industry in Ukraine faces a number of problems because of the lack of sufficient information on the peculiarities of the operating modes of wind farms under real-life conditions...
Analysis of Fuzzy Controller Application Efficiency in Two-Mass Systems with Variable Moment of Inertia of Second Mass
A two-mass system with variable moment of inertia of the second mass has been considered. Common approaches to controller synthesis of such system were considered. A fuzzy robust controller was introduced. Comparison of...
Determination of Hydro-Erosion Wear Coefficient for Sealing Elements of Pipeline Fittings
A model of hydro-erosion wear of sealing elements was constructed taking into account a set of parameters that reflect the physical properties of the fluid and the material of the sealing elements, as well as the design...
Measurement of Roughness of Internal Surface of Measuring Pipeline in Real Time for Standard Orifice Plates
Methods for measuring the roughness of the internal surface of a measuring pipeline for projected rectilinear sections of a measuring pipeline and for rectilinear sections that are in operation have been determined. The...
Analysis of Exergy Efficiency and Ways of Energy Saving in Air Conditioning System for a Cleanroom
In modern technologies, which are related to energy transformation, namely in air conditioning systems, important places are occupied by equipment and processes, the objective estimation of value of its energy perfection...