ANALYSIS OF THE WEAR OF THE SURFACE LAYERS IN NATURAL SOIL CONDITIONS
Journal Title: Tribologia - Year 2015, Vol 262, Issue 4
Abstract
The following paper presents research on the wear intensity of the surface layers in natural soil conditions. The study was conducted with the steel type XAR 600 and 38 GSA on the cutting surface where welds of cemented tungsten carbides had been applied. The results of the measurements of hardness and the chemical composition of the tested materials as well as their structure are presented. During the study, the processes of the wear of specific materials in their friction were analysed. Based on the results obtained from the field tests, we may observe an increase of the resistance to the mass wear and geometrical wear that can be seen on the length and width of samples that have been welded with XHD 6710 electrodes that additionally contain chromium carbides.
Authors and Affiliations
Jerzy NAPIÓRKOWSKI, Magdalena LEMECHA, Piotr SZCZYGLAK
Keywords
Related Articles
- EP ID EP257260
- DOI -
- Views 55
- Downloads 0
Badanie mechaniki współdziałania stykowego ze zużyciem w układach cylindrycznych o wewnętrznym styku hertzowskim
Na podstawie metody autorskiej badania mechaniki styku w połączeniu cylindrycznym oraz kinetyki jego zużywania przy tarciu ślizgowym przeprowadzono analizę numeryczną obszaru zastosowania klasycznego wzoru Hertza dla ok...
THE INFLUENCE OF PULSE ANODIC PROCESS PARAMETERS ON THE TRIBOLOGICAL PROPERTIES OF THE NANOCERAMIC AL2O3 SURFACE LAYERS
The paper presents a study on the influence of production parameters of Al203 nanoceramics surface layers on the tribological properties in cooperation with the PEEK/BG plastic. The Al2O3 surface layers were prepared by...
WEAR PATTERN TESTING OF CERAMIC COATINGS UNDER RECIPROCATING SLIDING
A ball-on-plate system was used for the investigation of the wear of ceramic coatings. Coated stainless steel balls (Ø 5 mm) were sliding under constant load at a nominal surface pressure of 1,155 GPa on a ceramic coated...
THE ELECTROLYTIC SYSTEM PROTECTING A TURNING TOOL AGAINST TRIBOLOGIC WEAR
To protect the tribologic wear of a turning tool an additional electrolytic circuit with controlled electrochemical processes was applied. The conditions of the work of the controlled electrolytic system with the deposit...
Zastosowanie teorii zbiorów przybliżonych do oceny wpływu struktury geometrycznej powierzchni elementów łożysk tocznych na ich powierzchniową trwałość zmęczeniową
Powierzchniowa trwałość zmęczeniowa łożysk tocznych, kół zębatych i innych elementów maszyn pracujących w warunkach cyklicznie zmiennych naprężeń kontaktowych może być determinowana przez ogromną liczbę czynników i to za...