DEFORMATIONS AND FRACTURE OF COATING-SUBSTRATE SYSTEMS UNDER CONTACT LOAD
Journal Title: Tribologia - Year 2010, Vol 231, Issue 3
Abstract
Thin coatings are particularly applied to machine elements and tools working in contact. Theoretical solution of contact for coated systems is still not available, because of the difference in elastic and plastic properties of the surface layer and substrate, its interface properties, and residual stresses. Load bearing capacity of coatingsubstrate systems can be found from indentation experiments by transforming the load-depth indentation diagram to stress-strain diagram. The author depicts a complete procedure for this transformation. In the article, considerations about the deformations and failure of coating-substrate system were presented. Analyses were based on MES modelling and spherical microindentation results. TiN coatings on X6Cr13 steel substrates were under consideration. Critical loads leading to plastic deformation of steel substrate and coating fracture have been evaluated. Determination of these parameters allows one to make a deformation and fracture map for the tested system.<br/><br/>
Authors and Affiliations
Marcin Kot
Keywords
Related Articles
- EP ID EP517281
- DOI -
- Views 65
- Downloads 0
ANALYSIS OF FRACTURE OF THIN CERAMIC AND CARBON COATINGS BY MODELING AND INDENTATION EXPERIMENTS
In article consideration about deformations and failure of coating-substrate system by plastic deformation of substrate and coatings fracture were presented. Analysis were based on FEM modelling and spherical microindent...
THE INFLUENCE OF EQUILIBRIUM QUALITY PARAMETERS OF A SURFACE LAYER ON THE WEAR RESISTANCE OF PARTS
The article describes the processes of hardening and softening of the surface layer of parts in the process of wear during the formation of the equilibrium state of work surfaces of friction units. Based on the energy ap...
INVESTIGATION METHODS FOR ROLLING BEARINGS IN TERMS OF CURRENT REQUIREMENTS FOR HIGH PERFORMANCE PRODUCTS
As a result of the development in machine design, progress investigation in rolling bearing production is necessary. The criteria for bearings dictate the production of bearings for specific applications. This requires a...
THE EFFECT OF ELECTRON BEAM IRRADIATION ON TRIBOLOGICAL CHARACTERISTICS OF PTFE, POM, AND PA IN COMBINATION WITH AN ANODIC-OXIDE COATINGS
In this paper, the authors present the results of tribological and stereometric tests as well as the results of surface morphology of polytetrafluoroethylene, polyoxymethylene, and polyamide subjected to modification wit...
METODA DOBORU ŚRODKA SMAROWEGO DO PROCESU GŁĘBOKIEGO TŁOCZENIA BLACH STALOWYCH W PRZEMYŚLE MOTORYZACYJNYM, NOWE ROZWIĄZANIE I JEGO WERYFIKACJA
Przedstawiono wyniki badań tribologicznych środków smarowych obecnie stosowanych w firmie METALSA i zaproponowanych do stosowania przez Uniwersytet w Monterrey. Środki te wykorzystywane sa w procesie wytwarzania podwozi...