DEVELOPMENT TRENDS AND IMPROVEMENT WAYS OF A WIND TURBINE SIMULATION SYSTEMS
Journal Title: Електромеханічні і енергозберігаючі системи - Year 2017, Vol 3, Issue 39
Abstract
Purpose. To systematize the approaches to synthesis of wind turbine simulators and to develop the recommendations for the improvement of these systems. Methodology. Based on a comprehensive literature review, the generalized structure of a wind turbine simulation system is presented. The principle of work of wind turbine simulators is described. Designing features of an electromechanical system and a software-control system are analyzed. Results. Trends of designing of a wind turbine simulators are presented and improvement ways for these systems are developed. In most wind turbine simulators are constructed on the basis of torque controlled direct current or alternating current electric drive with simplified generating system of wind power plants as a load. Usually separately excited direct current motor driven by a controlled rectifier, or induction motor driven by a frequency converter can be used to reproduce the static and dynamic characteristics of real wind turbines. Wind turbines mathematical models usually takes into consideration dynamic effects of wind turbine like inertia effect, tower shadow effect, gradient effect, gearbox inertia and shaft elasticity to varying degrees without analysis of influence on simulation quality. The power-speed pattern of the wind can be generated from the data based on the Van der Hoven power spectrum or Weibull distribution, from the actual recorded wind speed data or from manual set up. Originality. The complex analysis of the features of the structural synthesis of wind turbine simulation systems is carried out and recommendations for improving the construction and effectiveness of use of wind turbine simulators are developed. Practical value. The obtained results allow to optimize the process of designing wind turbine simulators.
Authors and Affiliations
Oleksii Burov, Nataliia Vlasiuk
Keywords
Related Articles
- EP ID EP660462
- DOI -
- Views 168
- Downloads 0
SYNTHESIS MODEL OF THE PROCESS OF HEATING AND COOLING RODS IN THE PROTECTIVE HOUSING BASED ON EXPERIMENTAL STUDIES
Purpose. The work deals with processes of heating and cooling elements of the electrical machine for general cooling system control dependencies. The control actions of cooling fan drive are formed on basis of current se...
CONTROL SYSTEM OF GRID-TIED MULTILEVEL VOLTAGE INVERTER WITH LIMITATION TRANSFORMERS MAGNETIZING CURRENT
Purpose. Improved control law for gridtied multilevel voltage inverter of solar module that allows you to hold the solar module operation in terms of selection of the maximum power. Proposed an improved model of longitud...
CREATING A MOMENT OF RESISTANCE OF THE ELECTROMECHANICAL SYSTEM TWIN-ENGINE ELECTRIC LIFT MECHANISM SHUTTER DAM DRAIN WHEN STARTING
Purpose. The purpose of this work is to determine the factors of the formation of the moment of resistance to take them into account when creating an electric drive system. Methodology. The paper deals with the features...
RESEARCH OF ELECTROMECHANICAL SYSTEM OF VIBROCOMPACTOR WITH A CHAOTIC ESTABLISHED OPERATING MODE
Purpose. The article is devoted to the researching the possibility of creating chaotic regimes for the motion of the electromechanical vibrocompactor of the crucible induction furnace lining in order to improve the quali...
THE RESEARCH ON FREQUENCY-CONTROLLED ELECTRIC DRIVE OPERATION MODES UNDER FAULT-TOLERANT CONTROL
Purpose. In the paper the results of research on developed systems for fault-tolerant vector control, which ensure operability of frequency-controlled electric drive with presence of damages in power circuit of induction...