EVALUATION OF STRUCTURAL AND ENERGY PARAMETERS OF FRICTION PAIRS UNDER START – STOP MODE
Journal Title: Проблеми тертя та зношування - Year 2016, Vol 70, Issue
Abstract
The presented study identifies patterns that influence the kinetics of the formation of the boundary layers of lubricating mineral gear oil on activated friction contact surfaces, and the increment of the friction specific work on wear-resistant steel 40Х and ШХ15 in frequent start – stop operation mode. The analysis of the lubricating ability of oil at the starting maximum torque of friction showed that the thickness of the oil layer formed in contact has a dual nature – boundary and hydrodynamic. The differences are indentified in the increment of the friction specific work for steel brands under research in the start-up period at pure rolling as well in slippage presence, herewith, the energy intensity of contact is higher for steel 40Х. On kinetics of changes in the energy parameter for the researched steel brand is significantly affected by the structure of steel after quenching and tempering
Authors and Affiliations
O. A. MIKOSYANCHYK, R. G. MNATSAKANOV, A. Y. KUMURJY, S. V. SHAKULIEV
Keywords
Related Articles
- EP ID EP185931
- DOI -
- Views 85
- Downloads 0
POWER LOSSES OF GEAR SYSTEMS
This paper provides a review of experimental investigations and available models of gear load-independent power losses (windage losses, churning losses and air-oil pocketing power losses) for spur, helical, and bevel gea...
OPTIMIZATION OF THERMO-MECHANICAL CYCLIC STRESSES AT CRITICAL POINTS OF HOT-SECTION COMPONENTS IN GAS TURBINE ENGINES
Estimation methods of thermo-cyclic durability of high-temperature alloys in critical points of hot part components of gas turbine engine and in conditions of accelerated thermo-cyclic tests are given in the article. The...
ESTIMATION OF HEAT PROCESSES IN THE FRICTION CONTACT UNDER ROLLING WITH SLIPPAGE CONDITION
The influence of slip velocity at rolling with slippage on the intensity of heat release in the local contact at different modes of lubricating action was examined. Method of estimation of tem-perature resistance of the...
FRICTION WHEN ENGAGING BALL DETENT TORQUE LIMITERS
Analytical researches have been performed that studied the friction effect on the torque magnitude that triggers an overload release clutch, which means disconnecting its driving and driven parts. It has been quantitativ...
TRIBOBIOMINERALOGY – NEW DIRECTION IN SCIENCE OF FRICTION
These results and structure of biofilms and their impact on durability of aircraft alloys. Established that biomineralization surface layers of aircraft light alloy improves durability in 1.8-2.6 times.