COMPUTER AIDED SYSTEM FOR DESIGN & PROCESS PLANNING OF SPUR GEAR
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 2, Issue 12
Abstract
The design and process planning activity of spur gear involves number of iterations before an acceptable solution is arrived at. Doing this manually is error prone and time-consuming process. The present paper describes the development of a system to automate the design and process-planning activity for spur gear. The system is developed using the computer programming language Visual Basic 6.0 and Microsoft Access. The system is divided into five modules. The module 1 for Material Library form, module 2 for Machine Tool Library form, module 3 for Spur Gear Design form, module 4 for Process Planning form and is sub divided into Variant type Process Plan and Interactive type process plan and module 5 for generation of documented reports.
Authors and Affiliations
Vijay Kumar Karma
Keywords
Related Articles
- EP ID EP95531
- DOI -
- Views 78
- Downloads 0
HIGH SPEED LOW POWER 32 BIT ALU IMPLEMENTATION
The main objective of project is to design and verify different operations of Arithmetic and Logical Unit (ALU). We have designed an 32 bit ALU which accepts two 32 bits numbers and the code corresponding to t...
Enhancing Digital Images Using Feed Forward Neural Network
A neural filtering technique is proposed to enhance the digital images when images are contaminated by impulse noise. This filter is obtained by combining nonlinear filter and feed forward neural network with back...
STUDY ON POTENTIAL UTILIZATION OF SUGARCANE BAGASSE ASH IN STEEL FIBER REINFORCED CONCRETE
Aim of the project is to utilize the waste product produced by agricultural industry and enhancement of concrete strength by using steel fiber. Sugarcane bagasse ash (SCBA) is a left-over industrial byproduct which is u...
Fine Grain Dynamically Reconfigurable Architecture for CMOS Sram
Cell stability and area are among the major concerns in SRAM cell designs. This paper compares the performance of three SRAM cell topologies which include the conventional 6T-cell,8T-cell and 10T-cell. The cmos d...
Experimental Techniques to find Thermal Residual Stress in Composite Materials –A study of the Literature Review
If two dissimilar materials are joined at high temperature, a very high residual stresses developed near the interface of materials. The mismatch between the co-efficient of thermal expansion leads to stress conce...