Preparation and Tribological Properties of Ni Based Wear Resistant Coating by Plasma Cladding
Journal Title: 河南科技大学学报（自然科学版） - Year 2019, Vol 40, Issue 1
Abstract
The Ni based wear-resistant coating was prepared by plasma cladding technology on the surface of 20 steel by using the commercial WF260 alloy powders. The friction and wear behavior of the coating under dry friction condition at room temperature were investigated by the MM-200 tribo-tester. The microstructure and phase composition of the coating were observed by scanning electron microscope (SEM), energy dispersive spectrometer (EDS) and X-ray diffractometer (XRD) . The results indicate that the coating exhibites a lamellar structure and has a good metallurgically bond with the matrix. Some pores exist on the surface of the coating and a large amount of the dendrites are also found in the coating. The coating mainly consists of γ- (Ni, Fe), (Fe, Cr, Ni) mCn, Cr2Ni3, BPO4 and Fe5C2 phases. The wear rate of the 20 steel and the coating are 1.90 mm3/min and 0.26 mm3/min respectively. The wear resistance of the 20 steel is greatly improved by the coating. The main wear mechanisms of the coating are abrasive wear and oxidation wear, and the main strengthening mechanisms are dispersion strengthening and solution strengthening.
Authors and Affiliations
Mingming YAN, Sanming DU, Chao Liu, Yongzhen ZHANG
Keywords
Related Articles
- EP ID EP427023
- DOI 10.15926/j.cnki.issn1672-6871.2019.01.001
- Views 95
- Downloads 0
Effects of Annealing Treatment on Microstructures of Cu-Mo Alloy Films
Cu-Mo alloy thin films were deposited on flexible polyimide ( PI) substrate by magnetron sputtering method.The Cu-Mo alloy thin films were annealed in situ vacuum at different temperatures. The composition, phase structu...
Failure Mechanism of Joints Between New Type Concrete-filled Steel Tubular with Special-shaped Columns and Steel Beams
According to the experimental research of the concrete-filled steel tubular special-shaped joints with interior diaphragm,the failure process and the load-steel web strain hysteretic curves were analyzed,and the failure...
Cross-Layer Transmission Optimization Strategy in Wireless Sensor Networks
To solve the problem that the wireless sensor networks( WSNs) had lower transmission efficiency currently,a WSNs transmission optimization strategy based on cross-layer access was proposed. By cross-layer access mechanis...
Effect of Rolling Speed on Electrical Damage of GCr15 Steel During Tribology with Current
To understand the electric damage of bearing GCr15 steel during tribology with current, the electrical breakdown behaviors and the electric/tribological characteristics of 61808 bearings were studied under different roll...
Parameter Optimization and Simulation of Powertrain System of Pure Electric Passenger Vehicle
In order to improve the motor operation efficiency and the driving range of pure electric passenger vehicle,the parameter was matched for the power transmission system in the design process of pure electric passenger veh...