THE POWER FACTOR CORRECTION IMPROVEMENT FOR A SINGLE PHASE AC/DC CONVERTER USING AN ENABLING WINDOW CONTROL
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 4
Abstract
With the rapid development in the power electronics devices, DC power supplies are the wide range of application, including residential, commercial, and aerospace and traction system and SMPS. Normally, the conventional continuous conduction mode boost converter has been widely used for power factor correction (PFC) applications because of its high input power factor and simplicity, though it suffers from conduction loss in the input rectifier bridge and switching loss due to the high switching frequency. The efficiency decreases rapidly under the lower input voltage or the light-load work condition. In this paper, a novel Enabling Window Control (EWC) method is used to reduce the switching loss and to improve the efficiency. Moreover, electromagnetic interference noise and driving loss of the main switch can be reduced with the EWC method. And also we discuss and compare some of the dc/dc converters like buck, boost, buck-boost, cuk and sepic with and without using EWC method. Simulation results are obtained in the MATLAB/SIMULINK for the effectiveness of the study.
Authors and Affiliations
JEGADEESWARI G, DHEEPAK M, SARAVANAN S. V, VANISREE V
Keywords
Related Articles
- EP ID EP430405
- DOI 10.24247/ijmperdoct20186
- Views 65
- Downloads 0
Energy Potential of Sugar-Mill Byproduct Press-Mud Through Pyrolysis Process
Press-mud is the sugar industry left-over produced from the filtration of the sugar cane juice during the production of sugar. At present, it is a good source of fertilizer and utilized in soil quality enhancement in Ind...
Buckling Analysis of Thin Frp Laminate Under Combined Thermal and Mechanical Loading
Thermal environment influences the buckling behavior of structures, in addition to the mechanical loads acting on it. The present work aims to predict the buckling load factor of thin FRP laminates subjected to pressure...
Comparative Analysis of Water and Nano Fluid in STHE Using Computational Fluid Dynamic
In this current work, study has been conducted on the shell and tube heat exchanger. CFD was used to carry out the analysis of this heat exchanger. Fluent software was used to project the pressure distribution. The effec...
INFLUENCE OF HELICOIDAL CRACK ON DYNAMIC BEHAVIOR OF ROTATING SHAFT
The present study aims at the analysis of vibration characteristics of rotating shaft which contains single helicoidal surface crack. The shaft material is EN8. There are seven shafts out of one is intact shaft other six...
Transient Analysis of Wind Turbine Blades
In this paper, transient analysis has been carried out on the blades to determine the strength of the blade for different blade materials, steel and composite materials ; E - Glass, carbon fibre and aramid fibre by apply...