THE TRIBOLOGICAL CHARACTERISTICS OF THE POLYMER COMPOSITION IN THE RECIPROCATING MOTION IN THE PRESENCE OF ABRASIVE MATERIALS
Journal Title: Tribologia - Year 2018, Vol 282, Issue 6
Abstract
The article presents the results of the studies of resistance to abrasive wear of regenerative chemically curable a metal–polymer composite. The metal–polymer composite is used for the regeneration of guide systems of cutting machines and the classical construction association in steel-steel sliding guides. The tribological tests were carried out using a T–17 tester in reciprocating motion for various friction node loads of the 100 N, 150 N, and 200N. The studied combinations of machine oil contaminated by grinding dust of different chemical compositions were lubricated. Based on the studies carried out, it was found that the combination of polymersteel composite is characterized by greater abrasive wear resistance in the accepted study conditions than the steel-steel combination.<br/><br/>
Authors and Affiliations
Zbigniew PAWELEC
Keywords
Related Articles
- EP ID EP432517
- DOI 10.5604/01.3001.0012.8431
- Views 46
- Downloads 0
THE EFFECTIVENESS OF GREASES WITH FILLERS IN THE DEEP DRAWING OF STEEL SHEETS
The paper presents investigations into the influence of a solid lubricant being the filler in grease on the effectiveness of lubrication in the deep drawing of sheet metal with rigid tools. The lubrication effectiveness...
THE INFLUENCE OF ADDED WATER ON FUEL INJECTOR WEAR IN A DIESEL ENGINE
The article presents the problem of the wear of the components of injection apparatus of a self-ignition engine during the addition of water. The observer was subject to an injector from the KIPOR KDE3500E generator set...
OCENA ODPORNOŚCI NA ZUŻYCIE I KOROZJĘ ZŁĄCZY WYKONANYCH POMIĘDZY TYTANEM A STALĄ NIERDZEWNĄ ZA POŚREDNICTWEM Al, Cu ORAZ Ni
W niniejszej pracy połączono czysty tytan (Grade 2) ze stalą nierdzewną (X5CrNi18-10) poprzez spajanie dyfuzyjne z użyciem międzywarstw z aluminium, miedzi oraz niklu (100 μm). Badanie koncentruje się na porównaniu odpor...
TRIBOLOGICAL PROPERTIES OF ALUMINIUM OXIDE LAYER MODIFIED BY CARBON
The article presents the tribological and stereometric properties of aluminium oxide layers modified by carbon. The coatings were produced on EN-AW-5251 aluminium alloy substrate using a two-stage technology. The matrix...
CONNECTION BETWEEN STRUCTURAL CHANGES OF IRRIADIATED POLYETHER ETHER KETONE AND MECHANICAL PROPERTIES
The article presents the results of research on the impact of structural changes in polyether ether ketone (PEEK) on its mechanical properties. The polymer was exposed to gamma radiation at a dose of 50 and 150 kGy, and...