TRIBOLOGICAL PROPERTIES OF BEARING STEEL AFTER HYBRID TREATMENT, COMBINED DIFFUSION CHROMIZING WITH THE PVD METHOD
Journal Title: Tribologia - Year 2018, Vol 282, Issue 6
Abstract
The objective of the research in this work was the modification of the structure of chromized carbide layers on a bearing steel surface by the combination of diffusion chromizing with subsequent treatment, chromium nitride deposition by the PVD method, carried out to improve their tribological properties. As a result, CrC+CrN type hybrid layers on the surface of bearing steel were obtained. For comparison, the properties of single chromized carbide layers produced on a bearing steel surface in diffusion chromizing by the pack powder method were tested. Investigations of the layers’ microstructures, phase composition, depth profiles of elements in the layer diffusion zone, and hardness were carried out. Tribological properties (linear wear) of the layers were performed by means of taper-three rolls tests. It has been proved, that the resistance to abrasive wear of the CrC+CrN type hybrid layers is almost two times higher than that for single CrC carbide layers.<br/><br/>
Authors and Affiliations
Bogdan BOGDAŃSKI, Ewa KASPRZYCKA
Keywords
Related Articles
- EP ID EP432511
- DOI 10.5604/01.3001.0012.8410
- Views 43
- Downloads 0
ASSESSMENT OF TRIBOLOGICAL PROPERTIES OF MOTOR OILS
Results of tribological properties of fresh and used commercial oils were presented in this article. Effects for model samples with antiwear additives were compared. We used Four Ball Apparatus (FBA) and MT-1 machine for...
AN INFLUENCE OF MOLYBDENUM DISULFIDE CONTENT IN ELECTROLYTE ON TRIBOLOGICAL PROPERTIES OF ANODIC OXIDE COATINGS
The paper presents an estimation of the usefulness modification of anodic oxide coatings (AHC) on aluminium alloys with molybdenum disulfide (MoS2) for the improvement of the tribological properties of Al2O3 coatings. An...
DOŚWIADCZALNA OCENA DOPUSZCZALNYCH WARUNKÓW EKSPLOATACJI DLA ŚLIZGOWEGO SKOJARZENIA DLC/STAL
Przedstawiono przebieg i wyniki badań tarcia ślizgowego skojarzenia próbek ze stali wysokostopowej z powłoką DLC do zastosowań przemysłowych naniesioną na jedną ze stron skojarzenia. Badania stanowiły część prac związany...
FINISHING OF FLAME SPRAYED Ni-AL COATINGS AND AN ESTIMATE OF CBN INSERT WEAR
Highly accurate finishing of flame spraying Ni-5%Al coatings was carried out using sliding turning by tool with CBN cutting inserts. Flank (VB) and attack (KB) wear indexes of square and trigonal cutting inserts while ma...
ESTIMATION THE INFLUENCE THE TYPE OF FILLER ON THE RESISTANCE TO EROSIVE OF EPOXY COATING
The paper presents influence of micro- and nanofillers on erosive wear of coatings modified with the use of these particles. Glass microspheres of differentiated diameter values not exceeding 30 μm were used as microfill...