Demodulation of PDSM Signal by Using Multiple Sampling Technique
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2017, Vol 5, Issue 4
Abstract
The design of modulator and demodulator for wireless optical communication systems is one of the important issues. In this paper, a new receiver scheme is proposed for PDSM (Pulse Dual Slope Modulation) architecture which is used for VLC (Visible Light Communication). It is shown that the scheme that is referred as multiple sampling technique based demodulator architecture in this paper has lower BER (Bit Error Rate) than that of the traditional dual sampling demodulator architecture. However, the proposed demodulator has lower bit error rate performance compared with the traditional PDSM receiver scheme. The proposed receiver is designed on FPGA (Field Programmale Gate Arrays) complier. According to FPGA complier’s simulation results, it is shown that the receiver succesfully estimates data bits.
Authors and Affiliations
Mehmet SÖNMEZ
Keywords
Related Articles
- EP ID EP489242
- DOI 10.29109/http-gujsc-gazi-edu-tr.305295
- Views 130
- Downloads 0
Effect Of Coolıng Rate On Mechanıcal Propertıes In Resıstant Weldıng Joınt Of AISI 304 Staınless Steel
AISI 304 stainless steel plates are widespreadly used in automotive, food and chemical industries. These materials are joined by resistant spot welding. Mechanical properties of resistant spot-welded sheets are changed b...
Design, Manufacturing and Performance Test of Direct Solar Powered Heat Pump of Evaporator
In this study, the heat pump set-up was designed and manufactured by using principle of a vapor compression refrigeration cycle and its componenets. R404a was used as refrigerant and 1,71 m2-solar collector, instead of e...
Energy Saving in Industrial Annealing Furnaces
In this study, an energy efficiency studies have been carried out in a natural gas-fired rolling mill annealing furnace of an industrial establishment. In this context, exhaust gas from the furnace has been examined in t...
Determination of Optimum Cutting Parameters Affecting the Surface Form Properties in the Ductile Stainless Steels with Gray Relational Analysis Method
In this study, the effects of cutting parameters with different coatings (TiAlN and TiN) on drilling performance were investigated. Drilling operations were carried out on duplex stainless steels by drilling holes 20 mm...
Structural Analysis And Weight Optimization Of Recumbent Mouth And Calibrating Machine
In this study, basing on the structural analysis, the topology optimization of horizontal mouth opening and calibrating machine used for wheel rim production machine was analyzed and considering the critical values of Vo...