OPERATIONAL RESTRICTIONS FOR REDUCING NOISE AND THE SAFETY OF AIR OPERATIONS
Journal Title: Scientific Journals of Silesian University of Technology. Series Transport - Year 2017, Vol 94, Issue 94
Abstract
Many European airports are located in close proximity to residential or protected areas. Aircraft noise emissions caused by the landing and taking off of aircraft are a big problem in these areas. From an operational point of view, the method for reducing noise is to reduce traffic volume or change its organization, especially during the night. Some procedures and tools have been developed to support air traffic management in the implementation of operational constraints necessary to maintain noise at an acceptable level. The objective of this paper is to analyse the effectiveness of these tools. For this purpose, we have analysed existing methods of operational noise reduction, taking into account their influence on the structure, smoothness, punctuality and, especially, the safety of air traffic. As a result, existing risks have been identified, while methods have been proposed to combine two important air traffic service tasks: ensuring safety, while taking into account the environmental constraints, especially in relation to the acoustic climate.
Authors and Affiliations
Anna KWASIBORSKA, Jacek SKORUPSKI
Keywords
Related Articles
- EP ID EP329347
- DOI 10.20858/sjsutst.2017.94.9
- Views 65
- Downloads 0
ASSESMENT OF DYNAMIC LOAD OF THE GEAR ACCOUNTING INTERSTAGE COUPLING IN RESPECT OF ISOLATED STAGES
In the article presented and discussed were results from investigations performed on dynamic model of two-stage gear. A number of course features of dynamic coefficient value KV in the function of rotational speed of gea...
ANALYTICAL AND NUMERICAL METHODS TO OBTAIN CONTACT PATTERN OF CONVEXO-CONCAVE NOVIKOV GEARING
Article presents analytical and numerical methods to obtain contact pattern of convexo-concave Novikov gearing. Two TCA (tooth contact analysis) methods were given wchich are based on equations of differential geometry....
AN EXAMINATION OF VEHICLES AT THE BRAKE-CHASSIS TEST BED IN THE RANGE OF THE PARTIAL ENGINE LOAD
The performance of a ZI engine is presented in the paper, as well as a project involving a device for applying a partial load in the performed examinations of a brake-chassis test bed. The device was prepared for an Opel...
MATEMATYCZNY MODEL OBRÓBKI KSZTAŁTOWEJ UZĘBIEŃ O KOŁOWO-ŁUKOWYM ZARYSIE ZĘBÓW TYPU NOWIKOWA
Artykuł przedstawia model matematyczny kształtowej obróbki uzębień walcowych przekładni zębatych o kołowo-łukowym zarysie zębów typu Nowikowa za pomocą narzędzi krążkowych. Przykładami takich narzędzi mogą być frez krąż...
OCENA WŁAŚCIWOŚCI WYBRANYCH POWŁOK STALI 16MNCR5 POD KĄTEM ICH ZASTOSOWANIA W KOŁACH ZĘBATYCH
Artykuł zawiera ocenę właściwości wybranych twardych, cienkich powłok substratu 16MnCr5. W niniejszym artykule zostały opisane ich właściwości trybiologiczne oraz na podstawie krytycznej oceny, została zaprojektowana twa...