Processing of 5083 Al-Mg Material with Rolling (Galetage), Investigation of the Effects of Rolling Parameters on Surface Roughness and Surface Hardness
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2015, Vol 3, Issue 2
Abstract
Burnishing process is a post-processing operation used to obtain good surface quality. Burnishing process has some advantages such as increase of surface hardness and decrease of surface roughness on the surface work piece on which it is applied, resistance against material fatigue and abrasion resistance. As the main principle in this process is to crush the surface of material, this crushing mechanism and process parameters plays a key role on the roughness and hardness of material surface. In this study, 5083 Al-Mg material was burnished using different parameters as burnishing force of 100-200-300-400 N, feed rate of 0,15-0,25-0,35-0,45 mm/rev, number of revolution 100-200-300 rev/min and ball diameter of 11,112-13,494-15,081-16,669 mm. At the end of the process the effects of parameters used for the duration of burnishing on surface roughness and surface hardness had been determined.
Authors and Affiliations
Hüdayim BAŞAK
Keywords
Related Articles
- EP ID EP476157
- DOI -
- Views 93
- Downloads 0
Selection of Suitable Microorganism for Biocatalytic Oxidation Reaction of Racemic Propranolol
Propranolol is one of the β-blockers which are pharmaceutically important, especially used for treatment of cardiovasculer disease. In this study, the production of enantiomerically pure propranolol was aimed via biocata...
Contractors in the Construction Sector and R & D
Innovation is widely regarded as one of the key issues of national economic growth and competitiveness. Measurement of innovation and implementing it as a corporate culture is considered necessary as it is one of the key...
A Detailed Study for the Determination of Phase Inductances of a Shaded-Pole Induction Motor with Variable Air Gap
Shaded-pole induction motors (SPIMs) are extensively used in industrial applications, home appliances and ventilation systems due to their simple structure, low cost and low maintenance requirement. Formation of elliptic...
A Novel Design Process Model for Manufacturing Based on Reverse Engineering
Engineering can be classified into two groups as forward engineering (FE) and reverse engineering (RE). Forward engineering method progress from the definition of the problem to evaluation, test, and optimization of the...
The Structural, Morphological and Electrical Characterizations of InGaAsP/InP Structure
In this study, InGaAsP layer is grown on InP substrates by using Molecular Beam Epitaxy (MBE) technique. The structural and morphological properties of InGaAsP/InP structure have been investigated by means of high resolu...