Structural and thermal analysis of automotive disc brake rotor
Journal Title: Archive of Mechanical Engineering - Year 2014, Vol 0, Issue 1
Abstract
The main purpose of this study is to analyze the thermomechanical behavior of the dry contact between the brake disc and pads during the braking phase. The simulation strategy is based on softawe ANSYS11. The modeling of transient temperature in the disc brake is actually used to identify the factor of geometric design of the disc to install the ventilation system in vehicles. The thermal-structural analysis is then used with coupling to determine the deformation established and the Von Mises stress in the disc, the contact pressure distribution in pads. The results are satisfactory compared to those of the specialized literature.
Authors and Affiliations
Ali Belhocine, Mostefa Bouchetara
Keywords
Related Articles
- EP ID EP167075
- DOI 10.2478/meceng-2014-0005
- Views 94
- Downloads 0
Tracking control of a balancing robot – a model-based approach
This paper presents a control concept for a single-axle mobile robot moving on the horizontal plane. A mathematical model of the nonholonomic mechanical system is derived using Hamel’s equations of motion. Subsequently,...
Implementation of a geometric constraint regularization for multibody system models
Redundant constraints in MBS models severely deteriorate the computational performance and accuracy of any numerical MBS dynamics simulation method. Classically this problem has been addressed by means of numerical decom...
Influence of high pressure and high temperature hydrogen on fracture toughness of Ni-containing steels and alloys
The effect of hydrogen on short-term strength, low-cycle durability and planestress fracture toughness of 10Cr15Ni27 steel, 04Cr16Ni56 and 05Cr19Ni55 alloys at pressure up to 35 MPa and temperature 293. . . 773 K was inv...
Helicopter rotor sailing by non-smooth dynamics co-simulation
This paper presents the application of a co-simulation approach for the simulation of frictional contact in general-purpose multibody dynamics to a rotorcraft dynamics problem. The proposed approach is based on the co-si...
Real-time human in the loop MBS simulation in the Fraunhofer robot-based driving simulator
The paper encompasses the overview of hardware architecture and the systems characteristics of the Fraunhofer driving simulator. First, the requirements of the real-time model and the real-time calculation hardware are d...